#2. How to build a recharger for DIY Power Box, the easiest way. Step-by-step video.

This video shows the simplest and easiest way to build a recharger for a DIY powerbox. To watch how I built this powerbox, please watch my 1st video: • #1. How to Build a DIY...
WHERE TO GET THE PARTS:
1) Cigarette lighter male plug - amzn.to/3wgn0nM
2) Lead Acid battery Smart Charger - amzn.to/3WuPPHu (I highly recommend to use a charger made specifically for lead acid batteries if using this type of battery. Also, get a "smart" charger, just like this, for this type of charger reduces to a trickle charge when the battery is full to avoid overcharging.)
***These are affiliate links. If you buy something through these links I may get a small share of the sale (at no cost to you).

[@MakeDoAndMend1]

Thank you for sharing. I do get concerned over the lack of safety fuses in some designs I have seen. With so much power it can lead to wiring burn out. I have had and seen a few failed USB outlets and boards with burnt cases and wires. I have probably have too many fuses. Cheers from old George in the UK 🇬🇧

[@brianmorisset4489]

I used an SAE connector hooked directly to the battery to recharge my battery. I also have an SAE port for solar charging, through a solar carge controller.

[@Zbee167]

This is great! Thanks for sharing.

[@diypowerbox]

Glad you enjoyed it!

[@timothyaguilar7727]

Great Info. I Wondered If The Cig Plug Would Work. Now No Need For another Plug

[@DragnetRadio]

Nicely done.

[@diypowerbox]

Thank you!