How to assemble a constant velocity joint on a Honda CRV drive shaft. Was taken apart to change carrier bearing.
Пікірлер: 16
@jfromthedesert9847 Жыл бұрын
I like you explained how it goes together and how to take it apart
@warmlandmobilebrakes2 жыл бұрын
Super helpful! You guys rock.
@chrisquesnel32952 жыл бұрын
You could have shown us how to take it apart
@danielrivas72247 жыл бұрын
thank you for this video I save good money
@diyprojects74215 жыл бұрын
What did you replace ,
@g.j.bboldtus69462 жыл бұрын
Good job.
@waynewayongi805611 ай бұрын
I have 1999 RD1 crv, is there a specific video on how to dismantle the faulty center bearing of the unit
@WhiteCavendish3 жыл бұрын
Now I really wish I had seen your video before destroying my boot based on bad advice from some other shitty videos. The good news is, they do sell that boot in some places apparently, so there's hope yet. Cheers!
@mo2k23 жыл бұрын
Just destroyed mine and watched this video right after fml
@resqdiver14 жыл бұрын
Is there a special tool to crimp the CV seal cup onto the shaft?
@diyprojects74215 жыл бұрын
Do u have the part # for bearing to replace, what was the problem with centre bearing .
@CHIBA280CRV4 жыл бұрын
Fantastic, would you happen to have one on replacing the center carrier support ?
@drumskas4 жыл бұрын
I'm in the same dilemma, I got all dismounted but dont know how to take the center support beating off of it, I already have the new part but it's hard to take this apart