2006-2012 Toyota Rav4 V6 Upper Intake Manifold Gasket Intake Removal How To

[@tube8533]

nice!

[@alexeysk8046]

Hi, just little advice to remove second 12mm bolt from back after removing the throttle. It will be much easier

[@ValleyMobileAutomotive]

@@alexeysk8046 Thanks for the tip 👍

[@tylerfelix7126]

Not relevant to this job but you do an 02 Toyota Camry motor I am in the process of doing mine now following your videos however for some reason the motor seems to be getting hung up on the back side by the bell housing is this an angle issue?

[@ValleyMobileAutomotive]

@@tylerfelix7126 is it getting hung up coming out or going in?

[@tylerfelix7126]

It was getting hung up coming out but turns out I was being an idiot there is a third bolt in that axle mount face palm!

[@tylerfelix7126]

New issue the car I’m putting the good motor in has a seized motor in it so I can’t spin the crank to get to the flywheel bolts any ideas???

[@ValleyMobileAutomotive]

@@tylerfelix7126 You might have to disassemble some of the bottom end to access the connecting rods. Unbolting the connecting rods from the crankshaft may allow it to spin.