Can you please post a video of you putting it back together
@brendonlewis64477 жыл бұрын
Did you do it without a gear holder
@jtp3367 жыл бұрын
Was wondering if you could answer a quick question. When I took my clutch apart and the case cover off, I found fragments of a blown seal (black seal, with a metal band). But I can't figure out where it may have come from in order to replace it. I tried looking through parts lists/diagrams and that's not helping. Do you know how many seals there are on the clutch case side, so I can go over all mine to insure they're in place? I have the one as shown in your video (yellow, next to the maim clutch/trans shaft). Thanks
@johnvalente58477 жыл бұрын
LeeRoy Dundlehay Yeah where the water pump goes There’s a hole where that metal thing goes in with the rubber black seal it’s for the water just look around it’s on the water pump side of the casing so if you’re looking at it and be on the right side where the water pump is either on top or bottom I can’t remember but I do know what you’re talking about
@johnvalente58477 жыл бұрын
LeeRoy Dundlehay actually I could see it it’s on the top of the casing that big round hole so if you’re looking at it it’s going to be the last gear on the right look on top the gear there’s a little round for mental think should slide in there with the seal
@jtp3367 жыл бұрын
John Valente, thanks, much appreciated.
@jtp3367 жыл бұрын
A little more digging, and I found where the mystery seal came from on my quad. I actually had the O-Ring and metal tube for the water passage, what blew apart on mine was the crank seal behind the gear that runs the counter balancer shaft (the metal I found was remains of the seal spring I guess). But thanks again for your reply, it at least gave me another point of reference to check. I'm new to the 450r, and having just bought a well used one, I'm trying to get all it's demons sorted out.
@donnierogers63864 жыл бұрын
Show me how on,,yamaha mono,350
@milovil6 жыл бұрын
What are the symptoms from having a bad starter clutch? I just bought a 08 Trx450er and it only starts on choke, i think it is the carburetor but wanted to know if perhaps this is also a symptom of a bad starter clutch. I appreciate your help.
@brandondillon56555 жыл бұрын
Don't know if you still need this info, but a bad starter clutch will make the sound of the starter spinning, but it's not connecting to the crank, so it will just sound like and electronic spin with no compression sounds. If it will only start on choke it's most likely a carb issue.
@mikecal5165 жыл бұрын
Brandon Dillon I just got a 06 trx450er and when I try to start it it makes a loud noise from the side and sometimes it just clicks. Is that my reduction gear or my start clutch
@chaosneeded4 жыл бұрын
But how the fuck did you brake the bolt free that holds the starter clutch
@nickolaslandon46407 жыл бұрын
My buddy paid a shop $900 to do this repair 🤦🏼♂️
@mythologicalmyth6 жыл бұрын
repair is when one puts it back together and it runs.......this was a disassemble video. did I miss the assembly link?
@tonylay22788 жыл бұрын
so i did this all went well but when i put it back together my clutch has no pressure y please help
@johnvalente58477 жыл бұрын
Tony Lay you must of put your clutch back wrong . Because there's really nothing to the clutch to put it back together the way you took it out it should have pressure so you put something really wrong the springs or something
@Chevyryder20129 жыл бұрын
Can you help me out if I have any question I got a 2007 450er the same thing happened to mines
@johnvalente58477 жыл бұрын
Charles Henderson I'm sorry I put it back together already a long time ago . It really isn't hard .