2008-2011 Mitsubishi Lancer Starter Motor Replacement (How to DIY)

This 2008 Mitsubishi Lancer is getting a new starter motor.
😎If this video has been helpful consider supporting us with a cup of coffee! 🙂
www.buymeacoffee.com/ValleyMo...
🛒PARTS LIST:
▪️ Starter Motor New: amzn.to/3wbmA1l
▪️ Coolant: amzn.to/3T21sDY
▪️ Intake manifold gasket (optional): amzn.to/3wtAJqI
🛒TOOLS NEEDED:
▪️ Coolant funnel: amzn.to/4bfMaCk
▪️ Electric ratchet: amzn.to/3Sw4W12
▪️ Flashlight: amzn.to/48OaGJi
▪️ Flex head ratchet: amzn.to/47PZwm7
▪️ Pick set: amzn.to/3u9AdNZ
▪️ Plier set: amzn.to/3uhTvRi
▪️ Socket and wrench set: amzn.to/4b6K8ob
▪️ Torque wrench 1/2: amzn.to/3AgaOB2
▪️ Torque wrench 1/4: amzn.to/493Xr70
➡️I am part of the Amazon affiliate program and get a small commission when purchases are made through the links provided.
🔺DISCLAIMER
The information provided by Valley Mobile Automotive (“we,” “us” or “our”) on this video is for general informational purposes and entertainment only and does not replace professional advice.
All information is provided in good faith; however, we make no representation or warranty of any kind, express or implied, regarding the accuracy, adequacy, validity, reliability, availability or completeness of any information on the video.
By working on your own vehicle, you take responsibility for the outcome.
Under no circumstance shall we have any liability to you for any loss or damage of any kind incurred as a result of the use or reliance on any information provided on this channel. Your reliance on any information on the videos on this channel is solely at your own risk.

[@Like20goats]

I appreciate this as a 2011 owner, helped me actually find my starter, now to just get the part and replace it

[@francoisxavier68]

One thing after you back up intake manifold is to Chek for dirt falling into intake runner.

[@yasserh.2649]

you can remove the starter from the bottom without touching the manifold , U already did BUT only Two trick that u need to do .... First free the wire coming from battery side to starter , so it will go with u down ( wire stopped u ) ..and there is a wire metal holder on the top of starter location ( free wire from it to let starter go down when u pull it) , Second: down left manifold metal bracket need to take off to get u more room ( 3 x12mm screws) and ur good to go ..

[@ValleyMobileAutomotive]

Thanks! The next time I do one of these I'll give that a try 👍

[@riscuit_4biscuit161]

you can remove the starter from the bottom without loosening the manifold, its weird but you can wiggle it out from underneath and put it back as well from underneath but it has to be in different angles wiggled back in place then you just tighten the bolts and then boom

[@ValleyMobileAutomotive]

I'm glad you were able to do it that way. That's how the manual says. I tried for like an hour wiggling, twisting, pulling but nothing was working 😕.

[@leronnurse]

That joint is far

[@leonardcooper2680]

Which ever way you cut it, this is a mongrel job..😢

[@ValleyMobileAutomotive]

I agree! If they gave you just one more inch of clearance this would be a breeze.