2009 Audi A3 2.0T FWD automatic transmission Rear main seal discussion / @woodyanddaffyduck
Пікірлер: 6
@therealpimpskillet5 күн бұрын
Just bought my son a 09 A3, and after fixing everything, I'm left with a lean condition, which i'm about 95% sure is his rear main, and I found it somewhat comical as you talked about your friend replacing his trans, and the shop not doing the rear main at that time. His mother has a Fusion that had a bad transmission, and the dealership did the same thing. Her rear main went soon after they worked on it, so out the trans had to come again. :( lol Out of curiousity, did you use another jack, or trans jack to pull the trans out? I've done my FWD V6 SHO's trans / clutch a few times, so I'm familiar with pulling a trans like this, but just curious what you used so you could 'wiggle' it loose and around everything.
@timidtornado28692 жыл бұрын
Thanks for the video. Agree, AUDi, VW, or whoever in zeeGermany is doing this needs to be replaced. And you are right , replace what you can now. Plastic everywhere. Its a shame they went this route. Not nice of them. Like anything, a little bit of extra work will make the job go smoother. Get everything out of the way. Its only bolts. Not a mechanic but isn't that thin metal "washer" a block plate ? Doesn't matter either way, "the thing" goes back in. Ok , time to flip a coin - I do or I contract it out. Thanks again,.
@textbook2o114 жыл бұрын
yo man it's not a hex if it's got 12 points. hex means six
@michaelwitmer75363 жыл бұрын
ITS CALLED HEX BECAUSE IT HAS SIX SIDES!!!!
@timidtornado28692 жыл бұрын
@@michaelwitmer7536 so whats it called....just looked it up DODECAGON...lol...Imma stick with can I have a 12 point Hex driverset....do notice some call them HEX TORX
@therealpimpskillet5 күн бұрын
@@timidtornado2869 They are triple square's. If you look at the way they are cut, the angles of the 12 points are 90 degree.