2010 Chevy Traverse ECM not communicating and no crank no start

[@howlinwulf]

Another common no crank no start is the connection behind the drivers door kick panel. Where the wiring harness plugs together.

[@GenericHotCheetos]

What number fuse was it?

[@luissalgado3784]

Or where are you located

[@IvanZenteno]

Replace the battery, starter, fusibles and computer still the same not able to crank the engine

[@juansautodiagnostic6199]

if you was local i would gladly help you out. i recommend taking it to a professional and get it diagnosed the proper way

[@rajandseema123]

P0089, p0300,P0302, 304, and 306 codes. Changed Fuel press regualtor + coils and plugs.. Not running properly. Has over 120k miles. Could it be an bad ECU

[@juansautodiagnostic6199]

I would take it to a professional.

[@michaelfrancis3261]

what did you do when we heard the tps? did you ground the yellow wire with a jumper wire?

[@juansautodiagnostic6199]

Yes to see if the relay close and send power to the other circuits that the ecm needed. There was a rub through wire that need to get fix

[@luissalgado3784]

Hello I have 2009 Chevy traverse v63.6 we rebuild the whole engine sensor and everything before have this problem the truck turn on fine but after while the truck just turn off and now don't star

[@darellwilliams9482]

What fuse did you replace

[@juansautodiagnostic6199]

i would test every fuse and find the one that is damaged. this isnt a full how to. i recommend going with a professional

[@jaymartin9468]

Huh… I was told to check my PCM. Jump it and it runs, shut it off, no lights on dash won’t even click over. Now my key is locked in the ignition. Good thing is doesn’t run. Can’t steal it.

[@howlinwulf]

Check behind drivers side kick panel ,unplug the wiring harness and check for burnt connectors. Huge bundle of wires with a latch style clip that holds the 2 together. It fixed mine

[@imsogilly2544]

Where are you from

[@juansautodiagnostic6199]

fort wayne, indana

[@ryanweller6242]

See my car cranks but no start.

[@harpergrace1222]

clean your grounds make sure they are on there right

[@LARRYELWIN]

Can't see anything you are doing on the opposite side of the car. Bad video position.

[@juansautodiagnostic6199]

Not a how to.

[@Carroll-ss3td]

I watched it all didn't learn mush