Dodge ram heater not working.. on 2010 dodge ram 5.7 hemi
Пікірлер: 21
@user-ox9ou3nn8w6 ай бұрын
Guys! You Rock! The world needs more people like you to post these videos! Thank you for saving me a lot of money and getting me through a cold canadian winter morning!
@berzerk9114 жыл бұрын
I had the no heat problem but it was some sort of computer problem. After some googling found this solution that worked. With the vehicle running set the HVAC blower to low Press and hold the recirculation button on the HVAC Control Head for 10 seconds and release. Now press and hold the recirculation button on the HVAC Control Head again until the recirculation LED begins to flash, then release. The system will perform a brief recalibration and reset faults. The customer will regain heat after the calibration is complete.
@braystonavila16854 жыл бұрын
Berzerk911 I was having the problem of passenger side blowing hot and driver side blowing cold and I went ahead and tried this and it made the air blow more warm then it was previously but for only a few seconds then went back to luke warm so I kept doing the recalibration a couple times and after one of the recalibrations the led light didnt stop blinking foes this mean there is something wrong with the computer?
@bmead1443 жыл бұрын
What do you do if after following these steps the recirc light doesn't begin flashing?
@codyburns41494 жыл бұрын
Hell of a a guy to post this. Ive worked at Dodge and seen some old scamster tech put the screws to folks on that one. Good job
@jadenreginald89913 жыл бұрын
Instablaster
@priscillacaudill14595 жыл бұрын
There is one on to of heater box you must remove dash to get to.
@fivestarvp4 жыл бұрын
Y'all guys just save me $500 nice video and thanks alot for sharing with us!!
@jasentmful3 жыл бұрын
Will the AC still work if there is blockage?
@SRR12133 жыл бұрын
@@jasentmful Should because cold air works when the heater core is covered. When you move the knob, there's a third actuator behind the glove compartment, apart from the other two they replaced (there are three total). The one behind the glove compartment controls the blend of hot and cold air. The heater core gets covered so only cold air blows through the cabin.