2010 Mazda3 Steering Wheel Removal and Replacement - CorkSport Upgrade

This videos shows the process of replacing the steering wheel on a 2010 Mazda3. We decided to replace the worn out stock steering wheel with aftermarket wheel from CorkSport. The new wheel has a flat bottom and much better grips. This is a great upgrade for anyone and can easily be done in a short amount of time with basic tools.
Parts needed:
New steering wheel
Tools needed:
Socket wrench
10mm deep well socket.
21mm socket
Phillips head screwdriver (#2)
Torque Wrench
DISCLAIMER
This video is intended for informational and entertainment purposes only. All repairs should be handled by a licensed professional. We, steveandthemilkman, are not responsible or liable for any damages, loss, or injuries that may result from or be related to the use of any methods or equipment shown in this video. We do not guarantee that the content of this video is complete or accurate. Any damages, loss, or injuries that may occur due to the use of any equipment or information provided in this video are the responsibility of the user only. This disclaimer supersedes any content of this video.

[@edwinmarroquin7600]

fell in love when you tested her out lol

[@Chadman333]

Very informative and helpful video. My son is putting on a steering wheel cover and it needs to go under the plastic lips of the controls, but they need to be loosened a bit to slip the edge under there. This will help a lot!

[@marktogni964]

Great video guys. I just replaced my steering wheel and every step of the way your video helped. Thanks so much.

[@hankpapritz2240]

Awesome video. Thank you guys, that was very helpful. Did anybody else notice the smoke near the ground in the last few seconds?

[@mreyn17]

Very good video, I wanted to know what all the bolt sizes were before I did this swap. Only bit of constructive criticism I have is to remember these are screws, not bolts. I.E. tight is tight, don't have to torque down on them so hard, there would be no way to repair that plastic if it snaps.

[@monkeydude3987]

Good video, I’m doing something similar on my ‘13 soon

[@gd3265]

I would like to have a dedicated voice assistant button on the steering wheel, which I haven't got in my Mazda 3

[@wasgim]

Will it fit for the automatic with paddle shifts?

[@datrandomdugggy5537]

2:23 now is it possible to remove the airbag from the shell its in?

[@mohamedahid7855]

Where did you get those carbon fiber pieces in the steering wheel?

[@steveandthemilkman1311]

They actually came on the car when I bought it used so unfortunately I am not sure where they can be purchased.

[@song-one1910]

Just bought my cs steering wheel and came across this comment. I hope you still have your speed3. Go to aliexpress then type in this: For Mazda 3 Axela Mazdaspeed 3 2010 2011 2012 2013 Carbon Fiber Stickers Steering Wheel Button Frame Chin Cover Car Accessories

[@bernardbinondo1967]

Where i can buy the after market steering wheel please?

[@steveandthemilkman1311]

It's from CorkSport.com

[@jasin_369]

Ganz super 👍

[@ocmulgeeog]

Should I be scared of my nuts getting blown away at point? I mean I have 3 daughters already so I'm done there. However, I do love them ❤

[@SeeHowItGoes]

Not when you disconnect power.

[@AceCyberstar]

So we just gonna gloss over the crushed soda can behind the horn?

[@pushingbroom]

I was wondering why he didn't re-install "that part" until I read your comment and re-watched the removal as I didn't realize it was a pop can. WTF ?

[@cameronb6673]

Cheap Mazda steering wheel very poor wearing marks