2011 - 2016 GM Tire Pressure TPMS Relearn Procedure Tire Rotation TPMS Relearn Tool (Chevy Cruze)

[@customdetailer0078]

Is this re-learn procedure required after every tire rotation?

[@DrShock]

Any GM vehicle with TPMS, so since around 2005 or so, will need this procedure performed whenever you rotate the tires, or swap a spare tire in, or replace the Remote Control Door Lock Receiver in the dash. It's the only way the onboard computer knows which sensor is actually sitting in which position on the vehicle.

[@customdetailer0078]

DrShock Thank you very much for the information

[@optimalwin8327]

@@DrShock Is it possible that the relearn process to make mistake on the position of tires, e.g. the computer thought the driver rear is driver front and vice versa? When this happen, how do you tell the positioning is wrong? Your video show the start position and end position, how do you know which tire is next? Thanks.

[@DrShock]

It would be highly unlikely for the body control module to make such a mistake. You follow along with the side that is flashing the turn signal lamp. If you make a mistake you can always start the return process again and redo it

[@johnwesley3813]

Bought one of these on Amazon for about $10.00 . Worked great on my 2011 Cruze. Thanks so much for the video 👍🏻🇺🇸💪🏻

[@michaelbrady6646]

Spot on. No fluff or filler time. Preferred method to not using a device filling tires to 55PSI risking one blowing out in your face and saving time Item is only 5.00.

[@abhayes1]

Thanks DrShock, this video was a huge help. I thought I was getting a faulty reading on one of my tires. I already had the relearning tool that I bought over a year ago and never used it. It turned out my sensors were not relearned after a recent tire rotation. You saved me a needless diagnostic fee!!

[@picturethis2676]

Very helpful. Thanks

[@Johndoes1]

Great. The video was right to the point and helpful!. Nice Job.

[@bonekollektor1659]

So if I have 2 blank lines for both back tires, do I need new sensors?

[@DrShock]

That would be a strong possibility if the other two are responding ok. Knowing the age of the two unresponding sensors can help confirm the diagnosis (usually the batteries go dead in them after around 8 years on average).

[@bonekollektor1659]

@@DrShock my car is exactly 8 years old, thanks

[@carlosssandovallucas9326]

tanks for the video

[@22Webstar]

So now instead of just letting out a little air, I have to buy a tool?

[@DrShock]

Its a professional mechanics tool. GM developed it because it cuts the dealership service procedure down to 1/5 - 1/4 the time of air pressure sensor triggering. Time is money.

[@jefinyacob6810]

Will it be able to learn the tire pressure if i use the old method of removing air from the tires??

[@DrShock]

Most GM vehicles went to requiring this type of tool for TPMS relearns starting in 2011. The air pressure method was 2010 and older only.

[@philbennett1145]

Hi, I'm having issues with the one I bought. Is the TX light supposed to keep flashing while holding down the button? Thank you

[@DrShock]

Like you see in the video at 2:00 the green light will _flicker_ rapidly during transmitting the TPMS position relearn code to the vehicle. If you're having problems getting a single tire to register (but the rest are ok), it's usually because the TPMS sensor battery is dead and the sensor has to be replaced. I have a separate video on my channel for how you replace those yourself - kzbin.info/www/bejne/hn_ChIirqLtloc0

[@tbrown717]

I had the bcm replaced on my 2016 chevy cruze. I tried resetting the tires and all of my sensors work because my car honked at each tire I went through. After I tried resetting all the tires (they all honked and my car honked twice when done) my dash still reads blank under each tire. Any advice?

[@DrShock]

Initial reaction is the BCM was not properly programmed using GMs SPS2 with the latest 2016 Cruze calibrations by VIN number and/or the correct tire type/size was not selected during the programming.

[@johnforde4514]

heyyy, will this help turn back on my sensor - if one of my sensors is blank on the menu screen??

[@DrShock]

Possibly, depends on if the sensors battery hasn't died. Typically that's the case when they go _offline_ and then you have to replace them like here - kzbin.info/www/bejne/hn_ChIirqLtloc0

[@jonathansedman4059]

Will this tool work for a 2019 gmc terrian?

[@DrShock]

It did for 2017 and 2018. I am not aware of any reason why it would not work for a 2019 but you can check with the seller of the tool to confirm before you purchase in case there's something unique about your vehicle.

[@outboardfixer]

Great help!

[@BigZeus]

Thanks!

[@niskibum5196]

You can buy this tool on amazon for $15, but the same exact tool on the GM website is $65. You used to be able to relearn your tpms without a tool, just by letting some air out of each tire. Hey GM, how bout you stop ripping off your customers?

[@DrShock]

It's not the same as the GM original, but the Chinese clone tool is certainly good enough for DIY and far more appropriately priced. I did a review of one of the best matching GM design low cost clone TPMS tools on another video here - kzbin.info/www/bejne/nKOyf2d8mstkoZo

[@rajaramjet6969]

I agree, what a joke. It's a money maker for the automotive industry forcing the average consumer to visit their dealership or mechanic for wheel service. ANd while you are they try and upsell, new brakes, shocks, tires or other services. With all of the computer technology out there i'm sure they could have implemented a learning mode using the vehicles onboard computer. It would be similar to the so called "Hand Shake" connecting a laptop to a router. After all most new vehicles today have onboard wifi and navigation.

[@ericflores5748]

This tool doesn't work on 305/35/24 tires

[@DrShock]

This tool doesn't have anything to do with tires. Presuming that your TPMS sensor doesn't have a dead battery, what's more likely is that you do not have genuine GM TPMS sensors, or a compatible aftermarket one, mounted inside the wheel so there's either a radio frequency incompatibility, or the more inexpensive aftermarket ones won't support this feature correctly. Most big brand aftermarket sensors support this GM feature just fine though.

[@ericflores5748]

@@DrShock the sensor on my truck are the originals, the only thing I think of is maybe because the valve is right in the center of the rim and the metal block the frequency of the tool

[@DrShock]

Yeah I've seen this happen on some trucks, interference from the larger metal rims or weak batteries in an older TPMS module. When I've hit that I've had luck moving the tools antenna to right against the lip of the metal rim in line with the valve stem and flat end of the antenna on the tire rubber like I show in 2:29 of the video rather than the usual way I show at 2:01 of the video (side ways antenna which is usually what's recommended). Basically holding the tool as if you're trying to push its antenna nose into the tire right at that point. It's really important the tool has a fresh battery in these situations, for maximum radio transmission power.

[@kokolovitch56]

I have a 19 Cruze, so this way of getting to service mode doesn't help me at all.

[@DrShock]

It's the same TPMS EL-50448 relearn tool as shown, but your DIC design has changed for how to get to the menu. The 2019 owners manual will explain to hold down the start button without any foot pedal contact to enter service mode. Use the arrow keys on the steering wheel to get into the TPMS tire view and press the checkmark to start the process on vehicles 2017 thru 2019.

[@StephenRoberts82]

@@DrShock thanks as well - will try this week !

[@grkvain]

So, So Simple, gotta give it to GM for Simplicity. 2018 Accord, Car of the Year :| Worst TPMS EVER.....! It gives you a message that You have "LOW Pressure" ALL Trims, EXCEPT the Touring Models, and That one you have to open the Honda App, on your Phone....GMAFB....Good hunting, not kidding, gotta go outside and Physically measure the Pressure on each tire...Laughable!!>>Traded!

[@pwee507]

Still can't believe this exists.... what !?

[@bobpayne2861]

Does not work on a 2016 Chevy Sonic LT. Total waste of time.