2011 - 2017 Hyundai Elantra p0017 Crankshaft position sensor Bank 1 replacement

[@angelraez6569]

The part I needed to see you skipped over. How did you get the clip off without breaking it

[@equalizedsoundautorepair48]

I used a flat head screw driver to release the clip. Is hard to do with one hand. I was able to towards the end on the video. You can see me use a screw driver.

[@SantiagoPadilla-g5j]

Beautiful. Thanks brother. 🤘🏽

[@equalizedsoundautorepair48]

You're welcome my guy !

[@144Torch]

I replaced this, the car starts and runs better, has power. However the code still exists. Any advice? I have had the cam on the exhaust side replaced, new timing chain. VVT intake and exhaust replaced, as well as camshaft position sensors.

[@equalizedsoundautorepair48]

@@144Torch Have you tried to delete the code?

[@BrentTech]

Props my friend. Thanks.

[@equalizedsoundautorepair48]

You're welcome my guy 👍

[@ashmat410]

Is that on the exhaust side

[@bernardodelacruz2644]

Saludos tengo el mismo problema lo único que no e remplazado es el censor ckp. Asta el piñón variable reemplase. Pero la lus sigue ahí

[@equalizedsoundautorepair48]

Sounds like you have a issue with your time in chain or belt . You also possibly may have a bad crank shaft itself.

[@marsmith3411]

Thank you

[@equalizedsoundautorepair48]

You're welcome 🙏🏼

[@greent3193]

I changed the crankshaft and camshaft position sensor and the engine light is still on; reading the same code P0017. What do you recommend I do next?

[@equalizedsoundautorepair48]

You possibly have a issue with the camshaft it self. If you cleared the code after changing them, and it came back on. I'd pay for a diagnostic to figure out the issue after replacing the sensors. If you haven't cleared the code. The light will stay on until the computer realizes it's changed.