2014 jeep grand cherokee V6 3.6L oil filter housing replacement

thank you for watching!!!!!
If this video was helpful to you and if you would like to place a donation, here is my Venmo and PayPal information. Or I would really appreciate it if you could share my KZbin channel on your social media. Links will be on the the bottom.
venmo.com/code...
www.paypal.me/...

[@Lion_Rey]

I just want to thank you. This video is awesomely made, good instructions and awesome lighting! And i dont have a clue how you got some of the things done while holding a camera! Thanks once again!

[@TheEleaticOne]

Timely video Brother! I’m gearing up to perform this job. Thanks for the tip on the fuel line especially! Much obliged!

[@TheEleaticOne]

Wait.. was it 7 or 8 bolts on the intake?

[@covertr3con801]

I damn near followed step for step and I have no clue what happened. Now my car is running super rough and now it sounds like it’s about to blow up. It’s was like misfiring making these loud pop noises. Idk what to do

[@JaboTheMechanic]

Check for vacuum leaks

[@henrymbernal310]

Where did you purchase the oil filter assembly?

[@JaboTheMechanic]

Amazon

[@tailfirst]

How the Fuel Rail clip works (which is NOT shown here! - annoyed face): kzbin.info/www/bejne/g6icnKSlbJt9gpI I also went ahead and pulled the wiper cowl etc. off - makes LOT more room, but the little clips at each end of the wiper cowl (hold flexible rubber sections to the fenders) are insane stupid things that you cant avoid breaking 😞

[@ZackFrisbee]

Was that 106 in lbs or 8.6 ft lbs for the housing screws?

[@johngracia9087]

I’m just

[@miguelalvarez1073]

I think I got this same issue. I Have a few questions. Did you drop any of the fluids? Oil coolant? Before doing the job. The aluminum oil filter housing fits a 3.6 2011 model. I hear that that upgrade is only for 2014 and later. Last, did you pressure tested before removing the original housing?

[@thezekeprelliottexperience4907]

I have a 2011 and it's the same thing bruh it'll mix fluids when it goes bad like oil on coolant and coolant in oil so make sure to flush both thoroughly if that happens after you change it you'll need a few filters and some cheap oil just to run through the engine

[@miguelalvarez1073]

@@thezekeprelliottexperience4907 I end up doing the job, the valley was full of coolant and the smell of cooked coolant was everywhere. with basic mechanic skills and some Harbor Freight tools it took me about a day of work to fix, saved money!

[@Rheaux]

Did anybody else see the massive crack in the throttle plate?

[@Rheaux]

49:00

[@boostboyracing]

Finally a good video