2015 Streetglide Special w/ D&D Boss Fat Cat and Woods 222 cams

[@maxxbenzz7842]

I have the same 222 cam and kit in my 96. 2 into 1 pro pipe. Dyno Jet Power vision. SE high flow. Love it!

[@commonsenseisntcommon5338]

I was just inquiring on a forum the other day wondering about woods 222 in a 96. I have an 09 road king. All in all your happy & would do it all again? Thanks in advance!

[@maxxbenzz7842]

I love it. Great cam for 2up riding. Very good low end torque. Not a race cam. Runs out out of gas at higher rpms. Just my opinion

[@commonsenseisntcommon5338]

Exactly the confirmation I was looking for! Appreciate the info!

[@taps_1021]

Beautiful bike

[@BafflingBS]

Danny Tapia thank you very much

[@michaelmikolajczyk]

I ordered the same rear ended and exhaust, Are the pipes flush with the bags and fender? I’m asking because on some forums they were saying that theirs were about 1/2 inside.

[@BafflingBS]

Same… Not quite flush, unfortunately. It definitely bugs me, a little. Probably would have gone with a Dragula II, had I known.

[@RoyalKennedy601]

Sounds great . Were you able to just do a cam swap without extra engine parts and work?

[@BafflingBS]

Thanks! It was nice and quiet. I did change out the bearings, gaskets and lifters. I also went with adjustable pushrods. You probably don’t have to, however, I chose to. You will definitely have to retune it, as well. These were a great set of cams.

[@alilmfmlfkgqlmfg]

Cool 💖💖🐈

[@BafflingBS]

Crunchy Cat thanks!

[@brucemunro3342]

nice bike!!!!what handlebars thanks

[@BafflingBS]

bruce munro L.A. Choppers 10” Twin Peaks

[@BafflingBS]

bruce munro thank you

[@BigObikes]

How does it work with those cams and thundermax in it I have the same bike wanting to do the same thing

[@BafflingBS]

It ran beautifully! I have a 110” now, but, it ran really smooth

[@troylizotte8810]

What kind of lifters and ajustable pusheod did you go whith

[@BafflingBS]

Woods Alpha Directional lifters, and who ever makes Fuel Moto adjustable push-rods. (Possibly Smith Brothers)

[@bryanwalker3110]

Did you do a map tune or a dunk tune? What tuner do you have?

[@BafflingBS]

It has a Thundermax which starts with a map, and auto-tunes. But my installer set the perimeters, based on needs

[@xstutterz9250]

Does the stock clutch hold up ?

[@BafflingBS]

Easily! However, I put an AIM/vpc in, just in case. It made the clutch lighter to pull, and added extra pressure up top, where you make the most power

[@davidcagle4067]

What baffle do you have?

[@BafflingBS]

I apologize. I just saw this question. It is a wrapped perforated baffle

[@BigObikes]

Did you dyno tune it when it had the tw222 cams and thunder max or just run one of thundermax base tunes

[@BafflingBS]

Not tuned, but, when I had the 110 done, he dynoed it prior to install. The numbers were underwhelming, 90/105. But, the lines were beautiful, and it ran fantastic! Had he actually tuned it, I’m sure it would’ve been closer to the 95/112 it had with a 2-1-2. Most likely, a bit higher.