2018 Ford Transit Radiator Replacement/FAST & EASY!

See How To Remove And Install A Ford Transit Radiator In (2) HOURS With Basic Tools‪@dairleautoclassicrestorati6892‬
This Demonstration is on a 2018 HD350 Ford Transit. It Will Save You Lots Of Time And Money!
#fordtransit#transit#radiator

[@torkjoy1]

I am about to perform this task tomorrow and this video helped me greatly

[@johnfallis2079]

Thank you for this we have a fleet of these. you saved me a ton of time.

[@CortezAutoServiceMobile]

Thank you for the video about to knock this out

[@edwardbowles5587]

Thanks for the tips and tricks. I'll be trying in the morning!

[@williamgoderwis8995]

update... I had to drop the lower rad support 4 10mm bolts but this video definlty helped

[@AJourneyOfYourSoul]

Great job. Thanks for posting the video.

[@daxtruman4530]

Awesome video sir!

[@dairleautoclassicrestorati6892]

Thank you!

[@armoricain]

Excellent video with very useful tips! Subscribed!

[@dairleautoclassicrestorati6892]

Thank you!

[@DHazex]

Thank you

[@carlosbarrios5699]

Thanks

[@brianmiller9701]

I have to do this job on a '15 Transit 3500 HD with the 3.5 ecoboost. I hope it will be just that easy.

[@shadowing48]

Still took me a while but a I have a 2021 v6. Front end is basically the same but some hoses and stuff are moved around.

[@dairleautoclassicrestorati6892]

The main thing you was able to do it yourself. Good deal!👍

[@seanschroeder1067]

Piece of cake, took me 10 minutes.

[@dairleautoclassicrestorati6892]

Awesome 👌

[@omarparanoes2150]

Thank you for the video but is it the same for the 2015 transit250

[@dairleautoclassicrestorati6892]

I wish that I could answer that. I will say that this vehicle is a HD350 Diesel.

[@ryanteegarden4099]

Great video. How did you determine how much coolant to add? Just keep topping off until it hits the mark on the reservoir?

[@dairleautoclassicrestorati6892]

That's correct.

[@presicionturning5672]

Good details. I like that. Quick qestion. Where is the Drives side srs crash censor location? And what wire harness hooks to it? I bought a salvage van and cannot locate where to put that censor and dont see harness plug that would hookup to the censor. Thanks

[@dairleautoclassicrestorati6892]

The sensor is located behind each Bumper. They cost around $25 -$45.00 each. If I am not mistaken. There should be a wiring harness located where it should be mounted. I hope that helps. Thank you for your comment!

[@fluevano2316]

what did you use to keep the hood up??

[@pamsharo4529]

Question - we had radiator installed 6 months ago, now has a leak and mechanic is saying it was caused by the fan assembly wobbling hitting it? Is this something that can happen? The fan assembly was installed 1 year prior to the new radiator.

[@dairleautoclassicrestorati6892]

@pamsharo4529 Maybe if it has a single Fan with a Fan Cutch. The fan clutch would have to be bad. If that was the case. I can't imagine the Drive Belt staying in place. There is a good amount of space between the Fan and the Radiator. Either way, if this shop is the same shop that installed the Fan assembly and Radiator. They are responsible for the repair.

[@TheMcdido]

Not an easy job, but definitely a DIY job. I did have a hard time aligning top bumper onto top of radiator rubber fittings. Any tip on how to align it would be appreciated.

[@dairleautoclassicrestorati6892]

You are right. Those top bushings can be tricky to line up. It sounds like your Radiator is sitting in the wrong area. There are two positions that the Radiator can sit in. You need to reset the Radiator. Once you do that. The top bushings will fit perfectly.

[@TheMcdido]

@@dairleautoclassicrestorati6892 yes, you’re right about setting the bushings in the wrong area of the bumper. Thank you for the tip!

[@mikesmultimedia]

Do you have a radiator coolant drain video. Need the best way to access and open drain plug for 2018 Ford Transit-250.

[@dairleautoclassicrestorati6892]

No sir, I have not made a video on that one. I will keep that in mind.

[@mikesmultimedia]

Thanks. I am subscribed so if you do post a video, I should be notified. Please include in the video any discussion on type of coolant needed or which brand and cokor will suffice. Lodt of info out thete, so that is confusing. Obviously, walmart products are oreffeted if possible versus named brands like motorcraft. But what ever video you produce should be informative. Note: They really made the drain plug hard to get to, perhaps alternative ways to flush out coolant coukd be discussed as well (ie, disconnecting hoses, or aftermarket flush kits too. Great, look forward to it.

[@dairleautoclassicrestorati6892]

@@mikesmultimedia 👍🏽 😊

[@user-ix8qf8nn4c]

do you think it is possible to replace the radiator fan without disassembling the entire front of the ford?

[@dairleautoclassicrestorati6892]

Yes I do. I plan to make a Video on that soon.

[@markl3132]

This is fast and easy????