220V 2 2kw VFD (Variable Frequency Drive)

[@jonymohammed4136]

Very nice , background music was great . I'm from Bangladesh

[@thomasbont2377]

Wonder what type of externel potentiometer you are using (how much resistance)?

[@Dtrmsc]

Hi, I’d like to run a 3 phase engine, 380v and 50hz. The master line comes at 220v. Is it possibile with this machine?

[@bol8lod]

I have same vfd 9600 1t00220gb . I need it to run a 2.2kw single phase motor. How can i wire it to power a single phase motor

[@bol8lod]

My motor has starter capacitor and running capacitor. Can I get red of the start capacitor?

[@bol8lod]

Also i see you are not using brake resistor? Can i ignore it?

[@bol8lod]

I was able to run my motor finally

[@bol8lod]

I configured the power rating of my motor in the vfd and connected the 2 motor leads to any two of the uvw in vfd output. Note: i had to disable phase power loss detection to get it to run

[@frobertopereira]

@@bol8lod Did you keep the permanent capacitor?

[@Simsy5861]

I have a 9100 series inverter 220V 2.2kw and want to run a 2.2kw220V 3ph CNC spindle which has an operating frequency of 400hz and 24000rpm. I am unable to work out the settings to get the spindle to operate efficiently. Can you help with a suggestion of what settings I need to change and perhaps what their values should be? I will only be operating the spindle from the VFD front panel. Any help will be greatly appreciated.

[@ГаражКастом]

Джон привет, очень многие мне пишут, что подключают тормозной резистор к частотному преобразователю серии9600, но он не работает, ошибка 06. Что не так с Вашими 9600, ощущение, что клеммы Р и В пустышка, и тормозного модуля в частотном преобразователе нет. Это очень печально. Сними видео про подключение тормозного резистора.

[@alexbezzubenko3741]

этот на букву (М)пейн молчит как рыба об лед((( я уже устал стучатся до него.....всё верно что клеммы Р и В пустышка, я себе весь мозг взорвал из за этого...хер меня дернул у него покупать фуфел этот

[@silviocezar6831]

I wouid like the parameterization for speed 400HZ CNC

[@mikefreedom5612]

Can I use this inverter to power an equipment 220v 1phase , 60hz, if yes how?

[@johnpei5400]

Yes

[@bol8lod]

@@johnpei5400 i have the same request. I have same vfd 9600 1t00220gb . I need it to run a 2.2kw single phase motor

[@boonpleagreanpeng8632]

please auto start sethow ?

[@qurbanovsaleh1801]

Hello, this is 220 380

[@alexbezzubenko3741]

джони give me wiring diagram 9600-1T-00400G B