1955-59 Chevy truck cowl/hinge pillar removal

[@kennethgeelhaar872]

This video is a big help to me on my truck. Thanks for making this video. :-)

[@25mpb]

I'm glad it was helpful and good luck with your project.

[@yeoldepirate783]

great stuff I have this to do on Ours This is a huge help Thanks

[@25mpb]

Glad it helped. Good luck. Thanks for watching & for the subscription.

[@pweezy68]

Nice work. Do you know the size bolt thread that the piller hinge is

[@ElderlyIron]

Nice piece...

[@MrSchrum]

I am going to have to replace my entire cowl and air vent on the driver side. Do you know if it has the vin holes?

[@25mpb]

I do not think so. The vin tags were spot welded on. You could rivit or vhb tape the tag back on. Good luck.

[@MrSchrum]

+25mpb how difficult was it to replace this? I have to have mine replaced and the entire top replaced

[@25mpb]

+Schrum Classic Trucks Sorry SCT I answered this earlier from my phone don't know why it's not showing up. I don't know what experience you have, but take your time, take lots of before photos & measurements for reference , make sure you brace everything before disassembly & realize it will take quite a few hours to complete. Good luck

[@MrSchrum]

+25mpb thanks man. Take a look at my video where I'm talking about the rust

[@25mpb]

@ElderlyIron Thanks Jeff, SEE YA!

[@MrSchrum]

My cabs left air vent kick panel area is pretty much shot from the inside. How would you clean the inside out of one if my passenger side isn't rusted through

[@25mpb]

+Schrum Classic Trucks Hey SCT, you don't have to replace the whole assembly like in the video. You can just replace the kick panel if that is all that is bad. There was too much rust on the inside & outside of mine. Replacing the whole assembly was the best way to go. Good luck. See YA!

[@25mpb]

I don't know what your experience is but if you take your time, take before photos , reference measurements & brace everything you should be fine. Just keep in mind it will take some time to complete.