300 Chrysler 013 front struts

[@BJSmith-st6zv]

Really helpful step by step. Everyone else I watched were taking off calipers, tie rods, and damn near the whole front suspension. Thanks for saving me time enough to enjoy una cerveza después!

[@Marty09933]

Hi BjSmith-st6zv you’re very welcome, brother. Glad the video could help. Now you’re talking cerveza time lol thank you very much for watching. I appreciate you.

[@hittz8331]

Very nice video Marty. Much appreciated.

[@Marty09933]

Hi Hittz thank you very much and thank you for watching I appreciate you

[@tubeguytommy]

Just what I needed. Thanks!

[@Marty09933]

Hi tubeguytommy you’re very welcome and thank you for watching. I appreciate you.

[@jimarmstrong2630]

I've watched other videos and none of them showed the release of the upper control arm, if you try to remove the strut without doing that, you cannot get the strut out, the geometry is such that you can spent the entire day trying to pry the strut out, and I know, cause I just did it. The hammer strike to the upper control to release it, great trick. I'll go back out there and finish up tomorrow. Thanks.

[@Marty09933]

Hi@@jimarmstrong2630 you’re very welcome. I’m glad the video helped you. You got this brother You’re doing a great job and thank you for watching. I really appreciate you.

[@moe3299]

Nice Job, feel better about doing it now thank.

[@Marty09933]

Hi moe thank you you got this bro not to hard just take your time and pay attention to how everything comes off thanks for watching I Appreciate you

[@tmann2555]

What if I tightened the bottom nuts before the top? Stripped one of the 3 and wondering do i need to loosen the bottom before torque the top? Thanks

[@Marty09933]

Hi T Mann no you’re OK that will hold it but whenever you get the chance replace with new strut thank you for watching brother I really appreciate you

[@layitdown33]

I purchased monroe strut but the nut wasn't welded on the replacements.

[@Marty09933]

Hi Layitdown33 that’s OK. It should come with the nut no worries it’ll be fine. Just make sure you put the nut tighten it up and you’re good to go.

[@jacairrdailey3252]

What if the nut doesn’t come with it

[@Slickvic2000-u7p]

What type of strut's did you buy dor the replacements

[@Marty09933]

Hi Slick Vic, i don't know what brand it was but the customer bought it online thank you for watching i appreciate you

[@tmichele8922]

Normally what is labor about?

[@Marty09933]

@@tmichele8922 anywhere from $300 up to $400-$500

[@Mr-qn5oj]

What's the name of the front strut

[@Marty09933]

Hi @@Mr-qn5oj sorry i don't remember the customer ordered them online sorry. thank you for watching i appreciate you

[@BennetPoncha]

nice work man

[@Marty09933]

Hi Life with Von thank you and thank you for watching. I appreciate you.

[@kingsports0961]

Refeeshing video its been years since ive done any kind of work 😅

[@Marty09933]

Hi Kingsports well brother it’s time to get after it again time to come out of retirement lol thank you for watching. I appreciate you. Good luck brother.

[@bigchaloopa]

Very nice work. Love your comments. What was the initial problem? Was the front suspension making noise, rattling as you drive over bumps in the road?

[@Marty09933]

Hi Bigchaloopa thank you and yes it was making noise Thank you for watching. I appreciate you.