How To Remove EPSON WF-2850 Printhead WF-2830 XP-4100

[@jimconverse5343]

Thank you, Very helpful.

[@303electronics]

You're welcome! I appreciate your feedback. Have a great day!

[@MRADefeat]

How do you clean it with it out? Water? Soak in water?

[@303electronics]

Hello. Here's a video on how to manually clean an Epson printhead: kzbin.info/www/bejne/sIC4Z5tjqLt_i6c

[@TrishKraftyBeauTEEKs]

do you mind sharing where you bought your replacement printhead?

[@303electronics]

I buy used printers, and since I have a few, I usually find a good printhead to clean and use. I do not have a source, but Amazon and eBay has a few listing. I haven't had any luck buying from outside of USA. I have purchased a few before, listed as "new". The printheads were definitely not new. They somewhat looked like they were, but the nozzles were messed up or clogged.

[@rosajuliasuarezbenavides4233]

One question, I loved your video and I did the same procedure but when everything returned to its place it didn't start and it said error during digitization☺What do you think I should do?

[@303electronics]

Hi. It seems like there is a problem with connection of wires. Make sure you have all wires connected. Sometimes the ink cartridge reader board is missed. It's a smaller wire.

[@rafaelaguilar5967]

She's funny!!! You make a nice couple. You made my job of installing this sensor a-whole-lot easier.

[@JonathanFC229]

Good stuff, maybe add a link to the side panel removal to lift the top part all the way. I found it but took a bit. Bringing back this $10 marketplace printer I found, before I go office space on it 😅

[@johnb7490]

Thanks

[@303electronics]

No problem! Have a great day!