30mm NIBBI CARBURETOR INSTALL AND REVIEW!

Рет қаралды 32,955

Күн бұрын

Пікірлер: 75

@Alfoy57 8 ай бұрын

Great video!! I bought the templar 250 5 speed model back in November! Did the nibbi carb swap two weeks ago, and man it did make a huge difference. Love it!!!

@D_gas_bob 22 күн бұрын

I've had my Templar 3 years. 3500 miles. My only issue was carb related. Didn't idle below 2400rpm. Xpro sent me a new carb that was adjustable, but had the air screw out 4 turns to run good, purchased a 30mm and it was worse. Ordered a jet kit and started experimenting. The exhaust was blue, so I tried bigger jets, idle has always hung about 500 rpm high then settled...??? I did get a decent idle, but went from 48 mpg to 37. Ran a while that way then pulled the 30 and went 5 smaller on jets in the 28 and got my mileage back, and good idle at 1 1/2 turns. Probably could have used the stock carb with the idle plug removed... still have the idle hang 500 rpm for about 10 seconds...??? Working great! Adjustability is key, .2 sec with 30, not much gain.

@sturgeo 9 ай бұрын

First comment‼️ Love the videos man I would love to see more OBS content! Im a US Marine and I’m in school right now and I watch your videos to kill my free time😅 I miss my obs so much and seeing you build that tahoe makes my soul happy😂

@lmfscrew 9 ай бұрын

Thanks man I appreciate it! Thank you for your service 🤘🏻

@sturgeo 9 ай бұрын

@@lmfscrew Thank you man! I’d love to see a giveaway for the tahoe I’d definitely enter. I need an obs again and that one is a beauty

@jesusapariciosilva 3 ай бұрын

Part list I got going: Bel-Ray 10W Fork oil Máxima Break in oil Antigravity Lithium Battery MZS Short handle Clutch U Clamp Steel Break Line DoubleTake adventure Mirrors Pivotrax Inner tubes Igreely 4g battery cables Nibbi Handle Bar Grips Fahren H4 LED light Nibbi Short Release Throttle Rhental 5mm Bar clamps Renthal Handle Bar Suzuki RMZ Plastics QuadLock Mounts Shinko 705 18/21 Street Tires JT Sprockets 40t Niche Gold 520 X Chain Máxima Racing Pro Filter Nibbi 30mm PWK Carburetor MSD Spark plug Boot Nibbi performance Ignition Coil NGK Iridium Spark Plug GoldPlug Magnetic Oil Plug JFG Full Exhaust WPS Rim Strip

@Angelcastillo-pn4ve 23 күн бұрын

I had a question did the jfg exhaust fit fully or you had to bend it a bit also which one did you use

@22YZ450FX 6 ай бұрын

I agree that the better carb and upgrades help the chonda bikes but one thing nobody mentions is that if you do increase the power it breaks every other weak part. In order Chain, Rear wheel Dampners, Swing arm bushings, spokes. After a year I sold it and got a YZ450FX.

@Artoconnell 5 ай бұрын

Thats half the Fun :)

@mazdaweeb3 5 ай бұрын

A few HP increase isn't going to break anything faster, except maybe the stock chain, but that should be replaced immediately anyway. Also, this same bike exists as a 300cc liquid cooled model with 50% more HP. Why did you even bother buying Chinese bike if you can afford a Japanese one that costs five times as much?

@22YZ450FX 5 ай бұрын

@@mazdaweeb3 I wasn't planning on buying the 450 when I got the TBR7. All in it's 10x more @14k with mods/addons.

@johncooper9976 8 ай бұрын

I just watched this and the Vader video, like the videos, would like to see more. Definitely going to purchase a Templar.

@HomeSlice4.0 2 ай бұрын

Nibbi makes great carbs, I put one on my ssr 125tr-bw, and it went from 36mph too 47mph on a 1/8 mile

@bwscreen 9 ай бұрын

Hey man, I’ve got a question, how’d you cut the cats off of Larry, I’m trying to do so with my 10th gen but I was wondering what to do with the rear 02 sensor, any advice would be nice, keep up the great work !!

@joshuaguidry6428 9 ай бұрын

also on the brakes my did the same thing when i wrapped the wires under the seat. when i did that one of the wires pulled from the connector . the lights would turn on but not bright up just like what you were saying .

@alangoodrich6590 Ай бұрын

I got the 250 m to 55 in 5th gear. 170mile on the odometer.

@GMCJay_lly 9 ай бұрын

2 strokes are WAYYYY more fun!!!!!

@jimstenlund6017 4 ай бұрын

Yeah, even a Chinese 250 two-stroke is like $6K now. RapeMeNow had a KX85 for $3,550…but who knows after they rip you a new one with their fees💸💸💸

@jamesmealing-gd8jv 3 ай бұрын

RollTide seen your garbage truck same one in Alabama bike sound different with that carb good job

@ethanandrus4718 9 ай бұрын

Love the X Pro bike need to buy me one soon!

@pat14lang 9 ай бұрын

I kinda want to try one of these bikes. I’ve only ridden ATV’s but have wanted to try a dirt bike

@jonasch4425 9 ай бұрын

wire in the tailight i seen this in another video ill try and find it for you solder point broke..

@ianlaughlin85 10 күн бұрын

The Nibbi carb only made it a tenth of a second faster on 0 to 60. Not a game changer.

@teeztoyz 8 ай бұрын

I did the Nibbi mod it ran perfect after install but after 5 min the idle started rising and wouldn't idle down. I had to almost completely screw in the air screw to get it to idle which caused it to run rich so ended up re-jetting both the pilot and main. I'm at about 300ft with 42* temps right now running 125 main/45 pilot from stock 128/40 and it ran perfect - (I thought) but after changing the spark plug it was still running a little rich(moderately sooty) so I experimented with different jet combos and needle positions but it runs best with the 125/45 to where the adjustment screws are in the proper range(per spec) and the needle in the stock 3rd notch setting. I've tried tweaking the air screw to lean it out but haven't ridden it yet to see if it'll go faster or if the mixture is right according to the plug color.. Previously it topped out at 67 on the speedometer didn't cross check with GPS but was facing pretty strong head wind.

@thomaspayne8542 3 ай бұрын

This is a Templar X? I thought the Templar X had a 6 speed transmission? I was counting shifts, and it sounded like you only hit 5th gear. Did you start in 2nd?

@mikejessie8671 8 ай бұрын

Have you tried running a better spark plug or a better coil

@hoopersbbq 29 күн бұрын

Is that a Templar X or a 5 speed version?

@mrsmel269 9 ай бұрын

good times guys !!! any time we can go chase is a great day . hope you get to go play in the water or bust out a scooter tomorrow. enjoy it and #livetoride

@JoelVelazquez-w2t 3 ай бұрын

Put a 17 tooth pinion gear ⚙️ and it should go much faster I have a 250cc and it's quick

@jimbowalker6683 9 ай бұрын

Yo you posted a video of a 2014 mustang gt 9 years ago whats that H pipe you had installed lmfaoo like what brand

@calebtaylor5154 9 ай бұрын

Where or What website did you get the dirt bike at

@wesleypoarch6124 5 ай бұрын

I'm guessing you stuck with the jets that came in the Nibbi?

@JoshuaGrados 4 ай бұрын

Yeah just the ones in the nibbi

@jacobdad2742 2 ай бұрын

Has anyone had any issues with their taillight? I can't get the running light and the break light to work together like they're supposed to. Only one or the other depending on how i switch the wires around.

@danielv9703 2 ай бұрын

Would you know what nibbi to get for a db36 it’s the Apollo 250 rx just the basic dirtbike model

@ty_martin1868 8 ай бұрын

How long did it take for the bike to be delivered

@Aden_lr 9 ай бұрын

Can we get more shorty vids please it’s such a cool truck I’d like to see more of it 🔥

@imperial.D.4188 8 ай бұрын

I thought the nibby 28mm goes on those not the 30mm

@oliver5911 3 ай бұрын

It ships with a 28, but the 30 fits without additional changes.

@johnpaoli4032 9 ай бұрын

We have the same exact bike, same color, same issues. Our rear tail light does not work when applying the handbrake or the footbrake we have checked both switches they function properly they sent us out the light switch, which I don’t understand why hopefully the tail light assembly is the problem. They’re sending it actually today it should arrive. Let me know if you have the fix also, Il let you know as soon as I get mine and get it on the bike. This might be my second comment cause I don’t know if the first one went.

@joshuaguidry6428 9 ай бұрын

check your wires directly under the seat that is under the rear fender . One of the wires i bet came out the connecter. Mine did the same thing .

@johnpaoli4032 9 ай бұрын

@@joshuaguidry6428 No, we have checked all the cables and connections still have the same problem. They are now sending the light assembly. we installed the nibbi 30 mm works great. now putting on 42 tooth rear sprocket.

@AmeeGoMurdøçk 4 ай бұрын

which one will better , Xpro 250 or Apolo 250, please can anyone let me know from their experience??

@fmslick7586 4 ай бұрын

do not use the factory idle screw

@brandonbennett7501 8 ай бұрын

How many miles have you put on the bike man

@repinrs 5 ай бұрын

Im 6ft 220 You think this would haul my rear end around lol?

@dirtysouthlogging 9 ай бұрын

New to the channel just started my own project 04 escalade PRIME TIME videos coming soon

@davidjulseth8667 Ай бұрын

What bike is that?

@A-SM1TH 9 ай бұрын

What size jets do you run in your nibbi?

@DD20841 9 ай бұрын

30mm

@blakeoblko852 3 ай бұрын

Templar X 6-speed. 14T front 42T rear. Emissions delete, cat delete. Powercore pro tork exhaust. NGK D8EA. Nibbi 30mm, slow 40, main 130, needle clip one position down from center. I'm at an elevation of 1400 ft. I can't stand a lean running carb, Fat is where it's at baby!

@snowfreak207 2 ай бұрын

@@blakeoblko852can u ride highway with it?

@tearoffabite 8 ай бұрын

I see you front forks have no suspension like my bike. I hate riding it off road it is actually quite dangerous. be careful on that beast. I think my bike has 6 miles on it that's how much i like it.

@22YZ450FX 6 ай бұрын

With my TBR7 I got 2 deepwell 5/8 sockets from lowes then put em under the spring screws after flushing and refilling with 15wt shock oil. I'm 6'5" 220 so I needed a LOT of help on the front end and that helped.

@emochick7118 4 ай бұрын

I’m 5’5 do you think I’d be able to ride height wise? I do ride motorcycles I just don’t know if this is too tall for me.

@newbieprepper-oo2kw 2 ай бұрын

Im 5.8 and a yz 85 lw is perfect size for me I would try one I bored and stroked mine its pretty fast

@angelomills2967 5 ай бұрын

New rider; Just picked up the Templar M I’m having the same issue with the throttle where it revs crazy when I turn to the right how did you fix it???

@onewheelup912 2 ай бұрын

Back off the cable from the throttle body have no tension on the cable adjust idle on car not on the throttle cable

@onewheelup912 2 ай бұрын

Carb*