3D Printed Front Splitter Pt.2 - Final 3d Print, Ready for test fit - 1969 Corvette C3

[@bradwiebelhaus7065]

Making progress.

[@rvmonkey1669]

It looks great! where you came up short at the point can’t you just bring it out to there and trim the wings back?

[@nicholasjackson3344]

I am going to fiberglass the outer shell part. So I will just extend the fiberglass out to match the front splitter.

[@MikeHarris1984]

You didn't design it to have all the panels snap together? Or use some plastic weld clips, the metal clips with a electric gun that heats it and sinks them into the plastic to hold? Or is this just a test to then make your own carbon fiber permanent splitter? Freaking cool design!!!! You might have a decent side Hussle selling carbon fiber ones if this is your first to make the mould Ewww don't use hot glue. You are adding material to the middle making it bigger. Should use a CA glue with spray setter to harden it on contact

[@nicholasjackson3344]

This is going to be the inner shell, I will lay fiberglass over the top of it to make it strong. From what I have learned from other people this is the way to go. I'm learning as I go. So we will see.

[@OzyMark]

Are you going to load the STL files for the splitter on Thingaverse?

[@nicholasjackson3344]

@@OzyMark I might after I get the dimensions more correct.