3DPrinted Jetboat - Adding Water Cooling

[@MCsCreations]

Brilliant work, dude! Really well done!!! 😃 Stay safe there with your family! 🖖😊

[@rcprinter]

Thanks! 😃

[@TheRattleSnake3145]

The super sprint rc has 2 impellers in series which makes the water pickup almost instant

[@rcprinter]

yeah I'm actually building it right now :) Just finished the sprint which is also very good! Should have the videos out soon! Awesome boats!

[@carloshnunez]

Nice 🔵🔵🔵🙂🙂🙂👍👍👍🔵🔵🔵

[@rcprinter]

Thanks!

[@dustinoldsen4224]

I saw in another clip you mentioned its all printed in PLA, and the note about a motor spacer of abs for heat reasons. Can you share any printer settings?

[@rcprinter]

It was a while back but I'm pretty sure its just a 0.2mm layer height 0.4mm nozzle and then a few extra walls in the slicer to be sure the hull wall is solid.

[@mattrandall7615]

where did you get fitting for the water to exit side of boat

[@rcprinter]

aliexpress

[@laurentludres]

Hello. Nice. What is the kv of your 3650 motor ? Tks

[@rcprinter]

This one is ~3600kv which is too high