Yeah I have had the pressure poppet leak and implements drift up. I have put seals in them but my neutral is too tight! Thanks for the demonstration!
@ryanhutsell2234 Жыл бұрын
Good videos. I have to work my SVCs over on my 2840 both are passing pressure.
@walnutridgefarms39752 жыл бұрын
That was great, I'm all set to try it on the 4450. Thanks Jon!
@scottthornton34275 жыл бұрын
A lot of good info!
@taylorjennings22184 жыл бұрын
Thanks for all the knowledge!
@jonstevensmaplegrovefarms37544 жыл бұрын
Thank you I would like to do a lot more of these in the future.
@FarmallFanatic5 жыл бұрын
Good to have parts 👍
@thomasfaucette166019 күн бұрын
a guy is a living person not a hydraulic valve its part of a machine
@jonathonhammond62743 жыл бұрын
Thanks brother. I have a feeling my 4440 scv is bypassing. My loader will shake until I move the right remote to float
@jonstevensmaplegrovefarms37543 жыл бұрын
chattering like that is usually a supply issue. Meaning the main pump isn't getting enough oil Either because you have leaks after the main pump And that oil isn't getting back to the charge circuit Or your transmission pump is not getting the oil to the main pump Because of a dirty sump screen or filters screen or filters or or it's getting worn out or you have internal leaks After the main pump anything leaking will usually get hot pretty quick There is a plug just to the right of your top link On the back of the transmission case mission case it takes a 1/2 inch square drive, If you take that plug out and start the tractor up do you have yeah it's practical up do you have oil spraying around in there or oil is air or oil running from the top down
@jonathonhammond62743 жыл бұрын
@@jonstevensmaplegrovefarms3754 I will have to check that. One thing I have noticed is the right scv will get hotter that the left one. I don’t have any chattering in the three point with I lift it just some chattering the in loader when I left it at 1500 rpms or more. When using the loader at 1300 rpms it operates completely smooth so I believe I have a hi press lk after the pump. What are you thoughts sir?
@stevecatron6503 Жыл бұрын
How do you know which side the angle end of cams go?
@stevecatron6503 Жыл бұрын
One of cams slid down and not sure if it was like the other one or the opposite
@jonstevensmaplegrovefarms3754 Жыл бұрын
Take a picture before they fall out of place. LOL it should be opposite of the other side as far as where that flat portion is. 4640jon@gmail.com send me an email I'll see if I can't find a picture somewhere
@stevecatron6503 Жыл бұрын
Lol yeah one slid before could get pic.i knew how one went and had faint mark where it had been bolted down before...or atleast i hope i seen what i think i did lol guess ill know if doesnt work right?!
@yaridisbatistatejada25394 жыл бұрын
para verla en español
@jonstevensmaplegrovefarms37544 жыл бұрын
To see her who in spanish?
@AntonioLopezGuzman075 жыл бұрын
Hello can you give me the part number of kit Thanks
@jonstevensmaplegrovefarms37545 жыл бұрын
Kit for the valves is "RE10924" For the coupler kit "RE66985"