I like your videos! They show how it REALLY is doing this work! I'm 62, I just did this! I don't want to do it again! Getting too old to be crawling around under these jeeps! 3 days to recover from a half day of work!!! I did both front and rear brackets...
@aaronhjelmstrom9727 Жыл бұрын
Definitely a much better install video over SFR's attempt at an instructional video. They completely left out the installation of the brackets themselves. 😂 Didnt show and of the drilling or holting. Just the cutting and finished product.
@5150MotorSports Жыл бұрын
Thanks Aaron for watching….
@aresbar3 жыл бұрын
nice install, pretty straight forward, you should make a video of them working on the road, like mounting a gopro camera in the back focusing the shackles moving up and down and the leafs flexing
@5150MotorSports3 жыл бұрын
That’s a great idea!!! Thanks for watching..
@DeveshSharmaFPV3 жыл бұрын
Did you do all the cutting with the fuel tank completely full or empty? About to attempt this tomorrow. Kind of scared about the proximity to the fuel tank.
@5150MotorSports3 жыл бұрын
Hi Devesh, I Honestly don’t remember, always better to exercise on the side of caution. Good luck on the install. Thanks for watching.
@The_Samsquantch3 жыл бұрын
Did it mess with the driveline at all? I'm about to pull the trigger on this mod but wondering if it's going to affect my driveshaft to the point of needing a new one. Currently have an Adam's in there that was built to the length needed when I installed the 5.5" lift on it. Also how much softer was the ride for you after this mod?
@5150MotorSports3 жыл бұрын
Hi Adam, I had no problems with the drive shaft work perfect, the ride and flex is much better than before. Thanks 5150
@marklaccroix51683 жыл бұрын
Awsome
@wurd233 жыл бұрын
1.Did you ever need a plate for those two bolts thru the floor? 2.what size drill bit did you use to drill thru the floor?
@5150MotorSports3 жыл бұрын
Hi Kai, thanks for watching, I have not needed to add the plats. I believe I used a 3/8 drill bit.