6mm Creedmoor 87 gr Vmax VS. 88 gr Hammer Bullet

Dalton doing a comparison on speed and groups on two different but similar bullets.

[@rogerray2545]

Damn good video appreciate you

[@Dmcquown]

Thanks for watching.

[@Off-target-xy6bx]

Nice rifle and nice shooting. Happy hunting 👍

[@Dmcquown]

Thanks for watching!

[@JeffBush-h6d]

Nice looking rifle and accurate

[@Dmcquown]

It definitely shoots better than I do!

[@waynemayle865]

Since i got rid of my 6.5 creed i necked do my brass to 6mm creedmoor loaded with h4350 an 87gr hornady boattail hollow point it's extremely accurate probably my favorite coyote bullet

[@Dmcquown]

I shot a coyote with the 87 vmax and it was absolutely devastating on it.

[@robertdunbar5854]

Don't have a 6 Creed but I use 75gr hp Sierras out of a 6mm Remington. Not fur friendly, bud lol

[@waynemayle865]

@@robertdunbar5854 I run 70gr nosler out of my 6mm remington there not bad on hides

[@robertdunbar5854]

@@waynemayle865 Haven't tried those. Will try and get some. Thanks

[@AlaskanBallistics]

I'm doing the same for my .308 SHTF loads. 150gr Barnes ttsx and 150gr hornady 150gr fmj... tried 44.2grs of h335... Got 2740s with the hornady fmj and 2790s with the ttsx in 18" aero build. now I'm going to try 44.5grs.

[@Dmcquown]

So it almost mimics my results. Nice!

[@robertdunbar5854]

Have a 1885 low wall hi grade in 6.5x55 swed. Great rifle but trigger is gritty and forend touches some. Other than that its a very nice rifle. What did you use to shim your forend? Great videos keep them coming.

[@Dmcquown]

That sounds like a great and interesting rifle you have. I used a credit card I had cut up two pieces stacked up under the front screw and one in the back. I took a dremel and opened the sides up some. If you take and push on the hammer and dry fire a few time it seemed to smooth the trigger up a bit. Thanks for watching!

[@robertdunbar5854]

@@Dmcquown Thanks for the tips !

[@awsomedude12345678]

The velocity is probably more effected by the cartridge capacity than the bullet deformation energy

[@Dmcquown]

You’re probably right the hammer being longer is probably seated in the case deeper and therefore makes more pressure. Thanks for watching.

[@Mike-xi4zt]

holes in paper do not look like straight though holes. I have shot a couple deer with 87 gr Hornady do not recommend them for deer, not reliable when you hit shoulder. I have a 1885 and the scope mount system completely sucks. If they had picatinny rail base it would be a major improvement.

[@Dmcquown]

Murphy precision makes a picatinny for a 1885. You can also opt for different moa rail too they’re just pricey.

[@MorrisOutdoors98]

Seating depth test will tighten that 88gr up

[@Dmcquown]

Very well could I have no need to improve any further due to what I’m using it for. Thanks for watching.