92-99 OBS rear brake and wheel upgrade/update

replaced the rear brake rotors with cross drilled rotors
rotors: 96 Chevy Impala
rims: Boyd Coddington's turbines

[@worstnightmare9772]

I just picked up a 94 suburban Silverado edition TBI 239k miles

[@Slicpartna]

What plans do you have for it?

[@worstnightmare9772]

@@Slicpartna we'll lol it passes smog needs a tune up complete I want to replace all the sensers egr valve I'm trying to find allll the sensers I think it's only around 6 counting the egr ?? Do you know?? But keep it for a Winter SUV going over I-5 though Oregon to California it has 4x4 my 2007 Chevy suburban LS is only 2wd so

[@Slicpartna]

@@worstnightmare9772 why are replacing all the sensors?

[@worstnightmare9772]

@@Slicpartna well when I drove it at operating temperatures the oil pressure was really low maybe I just need to get a tune up or just how it runs not sure about these years no oil light or anything no check engine lights nothing

[@Slicpartna]

@@worstnightmare9772 what engine do you have?

[@originalman8497]

Question! what happened to your other breaks that you installed was there a problem?

[@Slicpartna]

There wasn't any issues, I still have the rotors. I just wanted cross drilled rotors

[@originalman8497]

@@Slicpartna Ok! I’m going through madness with my 4x4 truck! I’ve had to change out the motor mounts a couple different times! the old motor mounts I couldn’t use! The only motor mounts I could use are interfering with my AC Compressor That sits on the bottom of my engine passenger side, so I had to remove the AC compressor for now also, I could not use long Headers because they sat right on my transfer case!

[@Slicpartna]

@@originalman8497 what kind of long tube headers were you trying to use? I heard that pacesetter had hearders for 4x4s

[@originalman8497]

@@Slicpartna Long tube hooker headers

[@originalman8497]

This application is OK! these headers are made out of cast-iron for later on turbo