ABAQUS Tutorial: Buckling and Fracture Analysis of a Very Thick Composite Cylinder under Compression

[@hnrwagner]

This shell is based on a frame of a bicycle and more of it will be shown later ! if you have any questions or suggestions, let me know !

[@liboyan4897]

Dear Prof. Wagner, how to avoid locking problems from shell structures? some numerial studies about this topic?

[@draffedraffe7570]

thanks for using time codes, could you please also give individual time codes for the model creation ? part, property, assembly, loads and so on

[@choching1801]

good video, thx

[@tinu8515]

Please make a video about Postbuckling analysis of FGM plate

[@hnrwagner]

kzbin.info/www/bejne/hWjMlnpmYsx3q9E

[@neajacob8470]

Plz can u make a video on cylindrical shell with crack.

[@shagatadas4331]

Hi Dr. Wagner, Thank you very much for making this video. I was following step-by-step of this model. However, I cannot mesh the part and getting a message: The selected region cannot be meshed automatically using the assigned element shapes. However, I am using the SC8R element as yours. Could you please tell me the reason behind this? Thanks in advance.

[@hnrwagner]

Did you partion the part ? sounds like a partition problem

[@BardiaNikpourian]

And this is how the ocean gate sub failed