Accessory Belt Replacement PLUS Tensioner & Pulleys PLUS Underdrive Pulley Install - Ford Focus MK1

Idler Belt / Accessory Belt Replacement
Idler Pulley / Accessory Belt Pulley Install
Idler Belt Tensioner / Accessory Belt Tensioner Swap
BONUS: Crank Underdrive Pulley DIY Guide
Swap out your cracked belts, and noisy pulleys. Every step shown.
Horus Works Products on Amazon:
www.amazon.com...
-- Please Subscribe If You’d Like To See More Videos --
Other Useful Ford Focus DIY Videos:
Coolant Reservoir Tank Replacement: • Coolant Expansion Tank...
Power Steering Pump Replacement: • Power Steering Pump Re...
Headlight Restoration: • Headlight Restoration ...
Rear Swaybar Install: • Sway Bar Replacement -...
How to Lower and Upgrade Your Car Suspension: • DIY New Lowering Sprin...
How to Swap a Leaking Coolant Pipe: • DIY Fix Leaking Coolan...
How to Stop Rust on Your Car: • How To Prevent Rust On...
How to Change Coolant and Water Parts in Your Car: • Complete Cooling Fix -...
How to Swap Motor Mounts Complete Guide: • How to Swap Motor Moun...
Valve Cover Gasket Replacement: • EASY: Valve Cover Gask...
How to Replace a Car Battery: • How to Replace a Car B...
Throttle Body Cleaning - How To Guide: • How to Clean Your Thro...
Clutch Master Cylinder Replacement: • Clutch Master Cylinder...
Oil Change Made Easy - Every Step Shown: • Oil Change Made Easy -...
Fuel Filter Replacement - How To Guide: • Fuel Filter Replacemen...
Changing Brake Pads Brake Discs and Painting Callipers: • STEP BY STEP: Brake Pa...
Cabin Filter Replacement - Pollen Filter Change: • Cabin Filter Replaceme...
Car Door Lock Fix - Actuator Replacement: • Car Door Lock Fix - Ac...
Car Key Battery Replacement: • Car Key Battery Replac...
Rear Axle Spacers Install Guide: • Rear Axle Spacers Inst...
Other Useful Car DIY Videos:
EASY: How To DeBadge Your Car: • EASY: How To DeBadge Y...
Windscreen Chip Repair Guide - The Costs, and REAL Results: • Honest Windscreen Chip...
Car Window Tinting Tips For Beginners: • Car Window Tinting Tip...
Snow Foam Test - Worth the Time and Money?: • Snow Foam Test - Worth...
How to Clean Your Car: • How to Clean Your Car ...
Follow on:
KZbin (Subscribe): / @horus_works
Facebook (Like): / horusworx
Twitter (Follow): / horus_works
Instagram (Follow): / horus_works
Disclaimer:
This video is made to entertain and guide you in your car journey. I hope you’ve learnt something new like I have by watching this video. Please note however that you are solely responsible for trying the techniques displayed. Please follow proper safety practices and understand that this channel is not responsible for any damage caused to you or your property when following along with the channel’s content.

[@flesh77]

Great work, i will use this video to change the alternator in my Mazda Tribute 2.0 Zetec 2002j. thanks for you work

[@Horus_Works]

Glad to see that the video is useful and I appreciate your comment! 👍

[@jdaniels1313]

Thank you for the video, helped me successfully complete the job on my 06 Focus ZX3! I was resisting pulling the motor mount but you helped me get over it.

[@Horus_Works]

Glad the video helped you get this done 😀

[@ACDC1998Zippo]

The theory suggests that your throttle response should be better, as there is less inertia for the engine to overcome. A lightened flywheel works on the same principle. I ve heard that a lightened flywheel is a worthwhile upgrade for the zetec engines. So if you ever need to do a clutch on the car, you may as well get a lightened flywheel

[@Horus_Works]

Thank you, this is good advice and I've heard the same... there is some talk that with the better throttle response also comes a reduction in torque, but I can't confirm that.

[@flycorvus]

High five, Erik! Horus Works channel is quiet active, good to see your progress. Greetings from Hungary!

[@Horus_Works]

Koszonom szepen 😀👍👊

[@thinky-whinky6464]

you are great! Greetings from Poland

[@nesadjordjevic5980]

Tottaly great

[@Horus_Works]

Thanks!

[@Abauto84]

Eric I love your videos your channel is just amazing 😍

[@Horus_Works]

Thanks legend, I appreciate your support 😀👊

[@janosfazekas992]

Very good job👍

[@Horus_Works]

Thanks!

[@multijerryz]

Gran video y en que buena condición tienes tu focus, me toca cambiar la banda y lo quiero hacer por primera vez yo en mi zx3, lo tengo en buenas condiciones pero no como el tuyo, saludos y gracias por la info.

[@r.f1376]

Top!

[@Horus_Works]

Thanks

[@nunosantos3578]

Great video!! Is this engine block the same as a focus st170? When you change the accessory belt, shouldn't you change the water pump? I think the wather pump is driven by the accessory belt..

[@Horus_Works]

Thanks mate. Yeah the accessory belt is driven by the water pump, and your ST170 block is the same as mine. No need to change your water pump if it's fine though, the accessory belt is very easy to take off at any time anyway. But if you'd like to see how to change the water pump in these cars then just check out my other vid: kzbin.info/www/bejne/oaW9imVvi71mb5I

[@user-hw1tv8uq2t]

Question does the mk3 fit again to my poor knowledge spinning the rollers like a water roller with that right?

[@MuaadElSharif]

What a treat to see two focus videos in one week. I'd like to ask you please: Why did you choose a Ford focus as a daily driver?

[@Horus_Works]

Hello Muaad 😊 so glad that you are enjoying the vids. To answer your question, I chose a Mk1 Focus for a daily because they are great driver's cars. If you're into driving cars, these things cannot be beat. They aren't fast, but that's not the point to the Focus. I love how this car can put a smile on my face even in city traffic. As they say, it's better to drive a slow car fast, than a fast car slow.

[@MuaadElSharif]

That's a good answer and I'm glad you enjoy it. Cheers

[@javilin197]

Muy interesante. Gran vídeo como siempre .

[@Horus_Works]

Gracias por tu apoyo como siempre Javier 👍

[@vianajulio]

Hi hello from brazil, I have a question, where u find this red Silicone Hoses?

[@Horus_Works]

Hello 👋 I purchased mine here: www.burtonpower.com/parts-by-category/cooling-system/silicone-hose-kits/ford-focus-mk1-silicone-hose-kits.html

[@FractalDimensionEU]

Great video as per usual, do you if the crank underdrive pulley works for the 1.6 engine? I'm waiting for more videos for the project!!

[@Horus_Works]

Thanks you mate, I appreciate you watching. I'm not sure if the pulley will fit a 1.6 but ask these guys, they will be able to tell you :) www.fswerks.com/collections/focus-2000-2004-dohc-zetec-2-0l/products/fswerks-crank-underdrive-pulley-kit-ford-focus-zetec

[@danilobenitez142]

Lighter means faster 😂 that was my same thought process

[@Horus_Works]

It's now maybe about 0.01sec faster 😆

[@danilobenitez142]

@@Horus_Works 😂😂😂

[@matthewmoore661]

Did you curse Mazda/Ford off camera when you found out the bolt wouldn’t clear without jacking the engine? Better question: what rims do you have in the car?

[@Laci_G]

Ismét nagyon jó videót csináltál. Köszi szépen. Esetleg nem mérted mennyivel könnyebb a gyárihoz képest ez a szíjtárcs? Esetleg hengerenkénti leömlőt vagy gyári st170 leömlőt nem tervezel feltenni rá? Az dobna pár lóerőt rá😁

[@Horus_Works]

Szia, a súlykülönbség nagy. A gyári szíjtárcsa 1.5kg, az új szíjtárcsa pedig körülbelül 300g. Azt tervezem, hogy hamarosan további frissítéseket adok hozzá remélhetőleg :)

[@Laci_G]

@@Horus_Works Az tényleg jelentős különbség. Kb olyan hatása lehet akkor mint egy könnyített lendkeréknek.🤔 Már alig várom az új videót. Csak így tovább☺️

[@Horus_Works]

Köszönöm szépen 😀

[@marty3469]

Hi mate, Yeah there's not a lot to write home about lol, maybe 3bhp but you should invest in a decent header and system to get more gains.. Are you going to try a 65mm throttle body soon?, those are fun to drive with. Mine will be off the road for another month as I'm doing the header, exhaust and intake mods , it's not my daily so I can take my time.. oh I'll let you know about the fiesta st brakes too later on.. Have you an email I can send pics to ? Cheers

[@Horus_Works]

I've looked for a 65mm TB a while back but no luck, I might try again... Exhaust and header are on the list! Send pics via Insta if you like :)

[@marty3469]

@@Horus_Works I had a 65mm in my last Focus 1.8 and it felt like the response doubled , bhp felt more but don't think so, just gave it loads of low down grunt . Trying to find them now is trying to find a piece of hay in a stack of needles ! Lucky I bought up on focus stuff 10-15 yrs ago so I may have a TB or two about spare . I'm not any social media except this one unfortunately, might see what antisocial media's the missus does lol, to contact you thru 👍

[@Horus_Works]

@Marty no worries at all - if you do have a 65mm TB I would definitely be keen 👍👍

[@sixxgunz3774]

I lucked out my buddy that sold me the car put on a 65 and it still performs great. 208k miles on the block with all maintenance done on schedule engine wise.

[@Horus_Works]

@SixxGunZ I need one of those in my life 😜