adjusting the hand break on AU Falcon Ute

[@alexwillis7093]

Spur of the moment video. I'm working on an AU Falcon 1 ton ute. It's a 3 seater so the handbrake is on the RHS of the drivers seat and it pulled all the way up with no handbrake. I checked on here and couldn't find any video on this very important part of a 1 ton ute. If anyone has any questions don't hesitate to ask. Also if you are not confident working on breaks, on any vehicle, then take it to a professional. The breaks are the most important part of any car and failure to do the job properly could result in the death or injury of yourself or others!

[@ascendediam]

Wacko

[@ascendediam]

so if you so called seen my video which era used more angles/tech/timing/defense/fluidity? The 70s-90s or the era louis fought in

[@J_S209]

Actually, if you turn it clockwise you pull it in, if you undo it anticlockwise it expands the thing and tightens / expands it. Best way is to set it and test it by pulling the thing apart which means unbolt the calipers etc etc. You have to pre load or set the Tappet length. Key is making sure the pin sits between the banksia arm and the bottom part of the tappet. That screw thing never works to adjust the thing properly.

[@ascendediam]

Lunatic

[@ascendediam]

so if you so called seen my video which era used more angles/tech/timing/defense/fluidity? The 70s-90s or the era louis fought in