Airsoft How To: Integrate Tracer Unit Into MP5SD6 Mock Suppressor

[@FudgDuck]

How did you fasten the cap back on to the mock suppressor, mine came off in one piece but it doesn’t stay on very well, especially with the tracer unit bumping into it.

[@Slashers_Hangman]

Since the cap still had a ridge around it when I pop mine on, I just typically wrap a piece of electrical tape around it to hold it on. My friend lined the lip on the inside of the mock suppressor with Velcro and just used Velcro to pop it on and off

[@Aao2010]

I have a question instead of doing all this if I buy a mock suppressor with a tracer built in can I just unscrew the old suppressor and screw in the mock suppressor with the tracer

[@Slashers_Hangman]

Yes you can do that, however you need a special thread adapter for the sd6 (either market or 3D printed) and figure out how to attach the threaded adapter itself. This method is just for those that still want the original look of the SD6 with its suppressor, but there are adapters out there for your own to be attached

[@SwiftScouty]

Which lighter BT tracer unit is this?

[@Slashers_Hangman]

It’s the AceTech Lighter BT Ultra-Compact Bluetooth tracer unit. The $100 one that can do the green and red tracers

[@SwiftScouty]

@@Slashers_Hangman thx boss

[@Jay-np9sd]

Is this for the elite force hk?

[@Slashers_Hangman]

This is, but I believe it should work for cyma models as well and similar versions of the SD6