Is the bike tuned? Or have a fuel controller, the plate helps prevent popping but if it’s still stock tune with the mods you have the bike is still lean and will pop on decel.
@tellieslyfe38872 жыл бұрын
It's not tuned from a shop, but it has HMF optimizer. So the jetting is compatible with the hmf slip on exhaust.
@bryanb10942 жыл бұрын
@@tellieslyfe3887 I didn’t realize how old the video is lol. Some pop on decel is normal when under hard engine braking.
@phillipautwell57232 жыл бұрын
@@tellieslyfe3887 I'm pretty sure your bikes fuel injected and you don't have jets.. you need to have it tuned for optimal performance.. you got alot on the table your not able to use.. the stock tune limits power and mph..
@tellieslyfe38872 жыл бұрын
@@phillipautwell5723 Yes sir! Bike is tuned. Check out my upgrades vid and you will see it has a HMF slip on exhaust, K & N air filter, with Fuel Optimizer. The optimizer is set to the recommended settings. 👌
@riverasphenomenalideas94753 жыл бұрын
Might be an exhaust leak. Make sure that the header is correctly placed in place and it is not lose. Nice bike!
@tellieslyfe38872 жыл бұрын
Ty
@SonicRaptor4 жыл бұрын
I have one and I still have a few pops here and there I don't think it'll eliminate the popping 100% but it did stop majority of the popping
@tellieslyfe38874 жыл бұрын
Cool. Thx dude. That makes sense 👌
@craigrodriguez81443 жыл бұрын
same here
@requintoarc072 жыл бұрын
i’m pretty sure that’s not how the seat cover goes on😂😂
@thethiefonthecross90922 жыл бұрын
I hope you're being sarcastic LOL
@martingarciduenasАй бұрын
Just installed and now backfires.just going to put it back to stock.
@tellieslyfe3887Ай бұрын
@martingarciduenas No, you're good.👍🏽 It's still supposed to backfire a little bit.
@chuckwalla3257 ай бұрын
Engine will still have some popping, even after deleting AIS.
@tellieslyfe38877 ай бұрын
Yes, this is true!
@chuckwalla3257 ай бұрын
@@tellieslyfe3887 this is discussed often in the Yamaha Grizzly group. Same 686cc engine
@kaseyjohns51692 жыл бұрын
Hey did you figure it out because my yfz450r is doing the same
@tellieslyfe38872 жыл бұрын
Hey, i was told that after Installing the block off plate, it was normal to have a little bit of residual popping. Also, I can say that lately I have not been hearing nearly as much popping as when I first put it on. 👍
@williambrady51814 жыл бұрын
Good video !!!
@tellieslyfe38874 жыл бұрын
Thx bro!
@supnacho74543 жыл бұрын
I blocked it off from the other side where the hose was connect to the sensor
@chrisrieger92013 жыл бұрын
I just installed block off plate and now the engine is running hotter then before, anybody else experience this issue too?
@tellieslyfe38873 жыл бұрын
Nahh, Can't say I experienced the same. Not sure what may be causing yours to run hotter.
@ElMCH-vb7xv2 жыл бұрын
Its normal
@kaseyjohns51692 жыл бұрын
Did you plug the part off on the intake boot good when I first done it on my yfz450r Iit was making the pops glow. After I fixed it from sucking air from that little hole in the boat it stopped glowing red