Thank you for this, helped me replace mine yesterday. I did however snap two 10mm spanners trying it the way you had it set out. In the end I raised the engine more to get a breakerbar on the end of the T50 bit and a large spanner on the outer splined bit. Wedged the spanner under the engine mount to lock it in place and rotated the breaker bar which got it moving in no time.
@wawayltd2 жыл бұрын
They do get real tight...
@justCommando2 жыл бұрын
Great video thanks. I was looking forward to the part you put the belt back on, that's what I need to do, but I guess if I loosed the tensioner then it should be easy
@wawayltd2 жыл бұрын
Yeah, 2 ways, either keep pushing the tensioner, either pin it.. Mind your fingers!
@justCommando2 жыл бұрын
@@wawayltd I got it back on today 🙌
@ed-_-77797 күн бұрын
Dunno about easy nothings easy work on when it comes to ford fuel filtered etc needing primed fords can be a pain if u dont have the knowledge or equipment
@tezraym3 жыл бұрын
Amazing you replied to me about this last week going to be doing it very soon thank you very much
@wawayltd3 жыл бұрын
Thanks, I hope it helps. I had some raw footage and put it together today.
@abomination177611 күн бұрын
Can u get easier access if you take wheel and wheel arch off or not?
@wawayltd11 күн бұрын
Sorry, it's been a while, I don't remember exact setup. You'll have to see for yourself.
@MrDanybeАй бұрын
Have a intermitant rattle of mine, its a 64plate 1.6 tdci. Replacing should solve this yes mate
@wawayltdАй бұрын
I hope it helps, but I can't guarantee. These rattles can come from various sources.
@abomination177611 күн бұрын
Mines the same I think it’s the alternator bearing so might need hole alternator I’m gonna look into it
@pauldaly6420 Жыл бұрын
Rather than raise the engine, would it be easier to remover the alternator lower mounting bolt, loosen the upper bolt and rotate the alternator upwards slightly?
@wawayltd Жыл бұрын
Good idea, but this Ford has 3 bolts and a bracket that hold the alternator. Not bad idea anyway 👍
@pauldaly6420 Жыл бұрын
Cheers. I have to do mine tomorrow. hoping I don't need to lift the engine. Strangely I have a 43mm pulley on the alternator and all the motor factors are stocking a 33mm wide pulley.
@wawayltd Жыл бұрын
It's also a very tight bolt in the middle.
@danieleghed76136 ай бұрын
I was about to remove the right side wheel and wheel arch for the job, it seems it is not needed
@wawayltd6 ай бұрын
Life is easy 😎👍
@mokraisamir82493 жыл бұрын
u make the very nice video and i lerne so much with u pls advice me which car is reliable vw sharan 2016 or ford s max2016
@wawayltd3 жыл бұрын
They are both good cars - depends what happened to them in the past. Personally I don't like automatic gearboxes - I don't know what to do if they break, it can get very expensive... Maybe it's just me 🤔
@SergSerg-yz9fx3 жыл бұрын
Good Staff 👌
@mokraisamir82493 жыл бұрын
Pls tell me if vw sharan 2014 it solid and good car and what about speed 136 cv 100kw you think that enough for this car 1.700 kg
@wawayltd3 жыл бұрын
All cars break down, especially those that are not looked after. My Sharan is on 420.000 miles and not complaining. Things can go wrong, I can't guarantee that your Sharan will never have problems. Depends what previous owner was doing to it, and what he wasn't doing is important too 😏 I don't know what 136cv means, my 2.0tdi is not too bad for a family (not racing) car.
@ingilteredebirsivasliakdem66183 жыл бұрын
thank you so much man
@wawayltd3 жыл бұрын
You're welcome 👍
@mokraisamir82493 жыл бұрын
psl u think 140 ps horse power that enough to push an heavy sharan
@wawayltd3 жыл бұрын
It's enough for me.
@mokraisamir82493 жыл бұрын
@@wawayltd thx so much
@wawayltd3 жыл бұрын
You're welcome 👍
@OsmanGaziPasha3 жыл бұрын
Thank you
@wawayltd3 жыл бұрын
You're welcome
@CrasySailor22 күн бұрын
Paldies!
@wawayltd21 күн бұрын
Lūdzu 😎
@AnthonyKenneally-i7b11 ай бұрын
What s the name of that tool
@wawayltd11 ай бұрын
Alternator pulley removal tool
@kwayeb44163 жыл бұрын
Please can you me a service?
@wawayltd3 жыл бұрын
Come on, it's so easy to do it yourself 😉
@ukaszrykowski218411 ай бұрын
Hi,can you send me pulley number? Yours engine is 140 or 163 power horse?
@wawayltd11 ай бұрын
I think that car had 163 horses. Sorry, but I don't know part number, that wasn't my car. And even that guy sold it already.
@mokraisamir82493 жыл бұрын
i want say 136cv that it mean 100 kw or horse power that enough for this car 1774 kg
@wawayltd3 жыл бұрын
I think it has like 140 horses, depends on the engine, some of them come with 170, depends on specification.
@grishablesov209810 ай бұрын
Хер только понял .точнее хер че понял по английски
@wawayltd10 ай бұрын
😁 Да всё просто! Это как велосипед - в одну сторону крутится свободно, в другую блокируется.