Aluminium Intake Inlet Manifold Upgrade on 2.0 TDI 16v VW Audi Skoda Swirl Flaps Delete

[@amdix1112]

When you changed the plastic collector for the aluminum one, did you also have to change the screws or did the same ones work for you?

[@MeFixingEverything]

Good question, shame I did not film it but I was in a rush. So had 2 I think chopped a few mm. I think.you can compare the thickness. Where aluminium is slimmer than the plastic, chop it.

[@TuberYou-eh4oy]

are there any differences in performance, does the engine have power at low revs after installing the branch without flaps?

[@MeFixingEverything]

according to the internet there should be loss of power at low revs, Me personally I think is pulls better.

[@ruki708]

Did it solve the oil leak problem after installing, i have the same problem with mine bkp?

[@MeFixingEverything]

No oil leak since then.

[@DeathOnDaddario]

Wondering if the bkd manifold would fit onto the cbab engine.. :)

[@MeFixingEverything]

It looks completely different, single opening inlet on the cbab.

[@DeathOnDaddario]

@@MeFixingEverything Swirl delete, It is.💪😎

[@MeFixingEverything]

Lol, good to know !

[@Addselwyn]

Hi when using this aluminium inlet manifold , you can just plug the hose for the actuator is this correct , there is no need to have the actuator connected , thank you

[@mcjjordan]

Is it only plastic manifolds that have the flaps?