✅ Ansys Fluent Tutorial | Y-Shaped Pipe Simulation with different temperatures | Ansys 2020 R1

[@RicardoHernandez-up3uh]

Thank you very much!

[@MAHMOUDETEMADDAR]

Thanks so much for sharing your knowledge.

[@ansys_cfd]

You're welcome friend Best regards

[@arteomng1]

That's cool😎! Thanks Ninja

[@ansys_cfd]

You´re welcome friend. Best Regards

[@alializadeh8195]

مرسی

[@samirpinjara6418]

thank you so much

[@ansys_cfd]

You're welcome friend. Best regards

[@thegojira444]

very nice! can you make a refrigerator analysis video?

[@ansys_cfd]

Thanks, I will try friend. Best regards

[@wajihailyas6576]

I am trying to change element size but it is again set to default element size.

[@Anubis_Mlbb]

thank you four your sharing, ı have a question how can ı calculate here bend factor(Kl) to find pressure loss, ı am try solving with hand too.

[@krishnajagadeesh6307]

Kindly request sir please make one vedieo for nonlinear analysis vedieo and bucking

[@ansys_cfd]

Thanks, I will try friend. Best regards

[@bibinoodlez]

is there any simulation tutorial where two different liquids injected into two different inlets? foe example, water injected into inlet1 and blood injected into inlet2. is it possible?

[@ansys_cfd]

kzbin.info/www/bejne/fnWwimaChKqYsJI

[@bibinoodlez]

@@ansys_cfd Thank you so much!!

[@neelakshipadhi8435]

Hello sir. Thank you for this video. I had 1 doubt. How is the air flowing through the pipe when the pipe is not made hollow in the geometry?

[@ansys_cfd]

Hi friend; In this case the fluid is water and there are three hollow (2 inles and 1 outlet).

[@lorenzoromero4180]

Hi! if i need to the solid rotate, which parameter i must change?

[@ansys_cfd]

There is a option to rotate in the Task bar