Anycubic M5s / Wash and Cure Plus First use

[@CGDreamsTutorials]

Since making this video I have made some adaptions which I will show in a follow up video soon. These adaptions are I got a proper mask that has the correct filters, the mask you get with this printer does not protect you from the VOC fumes. I got a Air Purifier to run right beside the printer while printing. This helps reduce the smell but the VOC fumes will not be eliminated. The monitor on this air purifier and in fact all I have found so far only sense Voc 2.5, the fumes from resin are smaller particles than this. I also ended up getting a 6" inline extractor fan with a Carbon filter and hose, this is to be fitted in my garage window. I made a stand for my mini heater to bring it higher, stand more sturdy. I also added a inline switch for this. amzn.eu/d/gIDUbwr amzn.eu/d/csanDhr amzn.eu/d/ayUUafB amzn.eu/d/gQAYRAR amzn.eu/d/7WNoL7i

[@roberthoffmann4703]

Does the Buildplate fits into the wash & curr Plus?

[@CGDreamsTutorials]

No, Unfortunately the wash n cure is not big enough. Also to add which I will address in a video is that for some delicate models the wash n cure plus is too powerful, it will break parts off some models.

[@Electrobeam673]

Do you have a link for the heater?

[@CGDreamsTutorials]

@@Electrobeam673 Here is the link to heater. I did make a stand for this to stop bring it higher and hold it more secure in place. I have also added a inline switch since this video. amzn.eu/d/cLXE688