Planning on getting the RV6 J pipe for my 08 accord. I'm loving that sound
@Heeltoe. Жыл бұрын
We're here for you, sell those RV6 all the time :) www.heeltoeauto.com/index.php?p=catalog&mode=search&search_str=2008+rv6+accord
@CLtotheTL3212 жыл бұрын
ATLP FTWFW! I have the full ATLP setup on my 2004 TL and I love it.
@angelpena81214 жыл бұрын
How’s your low end torque?
@Corkoth557 жыл бұрын
i wonder how each would sound on a stock accord v6 exhaust.... the price of the altp one is nice...
@NobodyLikesyou.3 жыл бұрын
I have the rv6 j pipe with 3 vibrant resonator, and it does give that rasp sounds
@Heeltoe.3 жыл бұрын
Yes, sort of a characteristic sound. Hard to suppress it.
@NobodyLikesyou.2 жыл бұрын
@@Heeltoe. I also I added ported runners, it changed the sound
@TheHappiestWheels7 ай бұрын
I just wanna note that the 3rd cat being deleted doesn’t matter everywhere. The third cat doesn’t even have a 02 sensor. The 02 sensors are generally up stream and down stream connected directly to the PRE cats on the block not the 3rd cat. And newer j series have the down stream 02 connected on the j pipe instead of the bottom side of the pre cats. 3rd cat delete doesn’t matter in Missouri where you still have to pass emissions etc
@georgedoughly63445 жыл бұрын
They both Sound Very Good, but I like the ATLP better!
@TOKEsomeBOWLS42011 жыл бұрын
I like the rv6 because it is raspier than ATLP. Both are very lovely.though. Its a TL.
@Nippledozer8 жыл бұрын
Thanks for the unbiased test!
@MrAsianAirsofter3 жыл бұрын
Your threads on AZ are very helpful
@Heeltoe.3 жыл бұрын
Thank you so much! Always trying to help if we can.
@MrAsianAirsofter3 жыл бұрын
@@Heeltoe. was wondering about running either of these with the stock exhaust (cat back section) do I have to source a 2.5 to 2.25 adapter? Has anyone made any kind of test pipe for that?
@Heeltoe.3 жыл бұрын
@@MrAsianAirsofter I am not sure what you mean, running just the j-pipe with the stock exhaust? It bolts up 100% no problem.
@farmanshaikh64055 жыл бұрын
Great video 👍 thanks for sharing!
@dannybannds4 ай бұрын
planning on pairing the atlp v3 j pipe with the atlp race pipe (deleting the 3rd cat) will there be an audible difference in exhaust tone? i only have a mid muffler delete currently
@KenyonPayne3 жыл бұрын
Are those power numbers in WHP or BHP? Also, was this the resonated catback?
@Heeltoe.3 жыл бұрын
This exhaust is non resonated. These numbers are at the hubs, so closer to actual crank HP.
@alucardhellsing6663 жыл бұрын
Can you install the ATLP jpipe without changing any of the other stock exhaust components and still get proper performance?
@Heeltoe.3 жыл бұрын
Yes you can, unsure what "proper" performance is though.
@bryanbosch70738 жыл бұрын
Would the rasp on the RV6 be there with the stock muffler?
@Heeltoe.8 жыл бұрын
+Bryan Bosch It may be to a small degree.
@jordan184mccart7 жыл бұрын
Whats the setup of the car revving in the intro?
@prestonjohnston42947 жыл бұрын
yeah i would like to know this myself
@Heeltoe.7 жыл бұрын
Don't quite recall the specifics, but it is a TL with an ATLP cat-back.
@moiseslugardo85013 жыл бұрын
How will the ATLP affect the sound if I already have a Tanabe Medallion Exhaust?
@Heeltoe.3 жыл бұрын
It will be just a tad more grumbly but not totally different sounding.
@jimmyle63053 жыл бұрын
So does ATLP still have cats? Will it pass OBDM emissions?
@Heeltoe.3 жыл бұрын
The ATLP V2 j-pipe will not touch any cats.
@mechanicalanimal83976 жыл бұрын
What’s the difference between the TL and the TLX? It would seem the TLX would be capable of what the TL could do and more no?
@josethebest976 жыл бұрын
Mechanical Animal the difference is all wheel drive, thats about it. Although tlx has more power from factory simple bolt on mods on the tl will make it alot faster than the tlx
@brianoconnor84798 жыл бұрын
although it's not designed for the Acura RL. it has the same J35A8 as a TL-S. I can use the same exhaust parts as it correct? like j-pipe and cat delete
@Heeltoe.8 жыл бұрын
+Brian O'Connor Well, yes, that is a good theory, but the RL also has an SH-AWD system so the pipes underneath are quite different, even up under the engine where the J-pipe needs to clear the transfer case.
@brianoconnor84798 жыл бұрын
+HeeltoeAuto awe man your right. I didn't think of that. but I heard it's the same j pipe as an MDX. and the MDX is AWD too. so theoretically it should be ok?
@marcusdisabella18818 жыл бұрын
+Brian O'Connor It would be closer but now the exhaust end is going to be completely different...
@matthewvalentine58485 жыл бұрын
I have an 06 Accord sedan j30a4 or 5? I'm assuming that they make an application for our j series cars as well?
@Heeltoe.5 жыл бұрын
Yes, we have pipes for 03-07 Accord V6 on our site. All engines fit the same for all 7th gen Accords.
@TheMajorPena9 жыл бұрын
Not fair. The RV6 was running on a ATLP exhaust. ATLP had home field advantage. Let's all see a video with the RV6 with the RV6 exhaust system.
@Heeltoe.8 жыл бұрын
+TheMajorPena RV6 really does not make a production exhaust, and actually such a test would be less telling than this one. You want to have the same exhaust with both j-pipes. This way you know what difference there is between j-pipes alone without the cat-back confusing the issue.
@whoathatsalotofdamage37186 жыл бұрын
Run the test on a j35 with both precat deletes and a takeda exhaust (3rd party)
@turbocharged95895 жыл бұрын
I want to see a comparison of the two with an otherwise stock exhaust system.
@JimyOfficial4 жыл бұрын
Do you like the rasp? Or you prefer no rasp
@Heeltoe.3 жыл бұрын
Personally we prefer minimal rasp.
@ua6jj328 Жыл бұрын
How much HP does the ATLP Jpipe add without tune ?
@Heeltoe. Жыл бұрын
Between 8-13 hp usually
@ua6jj328 Жыл бұрын
@@Heeltoe. is that with the whole ATLP Jpipe and exhaust (cat back) or is that just Jpipe with stock exhaust HP gains ?
@aoescool8 жыл бұрын
without the cat does it throw check engine light
@Heeltoe.8 жыл бұрын
the 3rd cat is not governed by a sensor, so no. Safe to go! But do keep in mind deleting cats is not street legal.
@aoescool8 жыл бұрын
sweet thanks.. i live in brooklyn.. as long as it passes the computer test we good!!!
@2cars105 жыл бұрын
Was the ATLP tested with the 3rd cat?
@Heeltoe.5 жыл бұрын
The ATLP Race Pipe was installed with the V2 j-pipe here.
@DarkVoid17948 жыл бұрын
would this work on a j swapped integra?
@DarkVoid17948 жыл бұрын
I'll add that I'm trying to produce a similar sound for my integra build without chopping up the bumper
@cheetoshotfries22893 жыл бұрын
Anychance heeltoe wants to donate an rv6 jpipe for my accord🥺
@Heeltoe.3 жыл бұрын
Hi! Really not likely. We aren't in the donation business, in general.
@bigdjenty66172 жыл бұрын
Does the altp remove the cat?
@Heeltoe.2 жыл бұрын
No
@alexbravo30002 жыл бұрын
Wait so which one is better ?
@Heeltoe.2 жыл бұрын
They are both great. The RV6 is better for low-end response, the ATLP is better for max hp.
@starscream422 жыл бұрын
The RV6 sounds like complete dog shit. Get the ATLP
@TheTrebinoEel5 жыл бұрын
Which version is the rv6 pipe?
@Heeltoe.5 жыл бұрын
The V3
@alexbravo30002 жыл бұрын
Which one addeds hp ?
@Heeltoe.2 жыл бұрын
They both do.
@richlee12897 жыл бұрын
Will this fit on a 2004 acura tl ?
@Heeltoe.7 жыл бұрын
Yes it will.
@bougelaal10 жыл бұрын
Will this fit on 09+ TLs?
@Heeltoe.8 жыл бұрын
+bougelaal Both ATLP and RV6 make j-pipes for 4th gen TLs. Order up on Heeltoeauto.com!
@thingsdemystified10 жыл бұрын
I love the rasp of the RV6. I don't get why people don't like the rasp. It sounds like a Ferrari!
@Heeltoe.8 жыл бұрын
+ThingsDemystified Some people like it more than others. Personal tastes will always vary! Heeltoe is here to help you decide what to buy based on your needs and desires.
@Horditruck12 жыл бұрын
ATLP FTW IS RIGHT
@792bnz Жыл бұрын
What would happen if I use atlp j pipe and rv6 hfpc on a 9th gen accord v6? I hear one is suppose to have more torque and the other is more top end. Does that mean I get a middle ground between the two?
@Heeltoe. Жыл бұрын
ATLP generally makes more top end power, and RV6 generally makes more low rpm power. Although the 9g ATLP pipe we designed to be a little more mid-high than just mid-range.
@792bnz Жыл бұрын
@@Heeltoe. thank you for the reply sir but I want to know what I can expect by using atlp j pipe and rv6 high flow pre cat. Is it a bad idea or will I still make sufficient power? I don't want to buy parts that will not perform optimally together. Thanks in advance
@Heeltoe. Жыл бұрын
Yeah those parts will work fine together. The cats and the j-pipe don't really work together in the way that you are thinking they might. They don't depend on each other to function optimally, in other words.