Audi A6 2012-2018 C7 Replacing Center Dash Speaker - Part 1: Removal

Removing center dash speaker from an Audi A6 2012-2018 C7

[@nickingvolboth]

Thx bro big help!!!

[@nattys4446]

Hi ,good job,what about a 3axial speaker there? Would you recommend that? If only change the dash ones,do you need any changes or upgrade to amplifier?cheers mate!

[@GetFitStayFit1]

Have the same issue with my A7 thank you

[@tonyevangelista6539]

What size speaker is that?

[@Johan-ng2oe]

can you remove it completely or do you get error codes? thanks for the reply

[@greeneyesman0224]

Is there a way to know on how many Ohm do they work? Idk if i would like to randomply replace it by size, would like to install a similar speaker in terms of working parameters.

[@ronnbot]

4-ohm is the standard for car speakers. That said, drivers in a composite speaker setup could have different impedance. In this case however, it's 4-ohm full range speaker being replaced with a 4-ohm composite speaker.

[@bleont3877]

thx brev

[@yeahhhhhsha]

did you upgrade the center speaker?

[@ronnbot]

I guess you could say that, but did it because the speaker was blown.

[@comewithme9029]

Is that the base speaker or those Bose?

[@PM-wt3ye]

It says BOSE on the speaker. so i assume its BOSE!?

[@piotrturowski5289]

what was the problem because I have the same Audi A7 2016?? 😏

[@ronnbot]

The speaker was blown, which is much more noticeable when using the phone over Bluetooth or listening to certain audio like AM radio where much of the sound is coming from this center channel.

[@piotrturowski5289]

@@ronnbot thanks 👍

[@MrBassRenegade]

My a6 does the same thing.... what a crappy speaker setup

[@ronnbot]

Part 2: kzbin.info/www/bejne/mmi4i3mDhLh6mtE

[@jouniranta-puska4699]

I feel like the car would sound better without this speaker even if you don't replace it with anything. Am I right?

[@ronnbot]

Normally I'd agree with you as I prefer a phantom center setup in my living room. However, you can't configure the car's audio system to disable the center channel, so you'd lose a lot of audio info.

[@marsh12123444]

Wohh! Manual had me removing 10x more parts. Should went to KZbin first