HOW TO REPLACE UPSTREAM OXYGEN SENSOR ON HYUNDAI ELANTRA

[@AutoRepairGuys]

Products that we use and recommend: ► Oxygen Sensor Socket: amzn.to/2Ph4n8L ► Oxygen Sensor: amzn.to/2L2hlUJ ► Assorted Fuses: amzn.to/4f6qJos ► Panel Removal Set: amzn.to/3YiMADu ►Torx Set: amzn.to/2hbyWgd ► Tool Set: amzn.to/3p5MM6t ► Screwdriver Set: amzn.to/3XRB28Q ► Engine Oil: amzn.to/3xBc8B9 ► Oil Filter: amzn.to/3w0Ulme ► Torque Wrench: amzn.to/32qyRwg ► Liqui Moly Engine Flush: amzn.to/3IiDBID ► OBD Scanner that we use most often: amzn.to/3I4MQfe ► Check out our Amazon Store for the tools and parts that we use: www.amazon.com/shop/worldmechanics

[@pabloramos2891]

I need the one for hyundai Elantra 2010. do you have it ?

[@danielramos5586]

Hello, your video is very hehpful, but the oxygen sensor i need to replace is the one that measures the catalytic converter and i have check and there's no sensor in the cat, there's one in the flex pipe and i dont know if that one is for the catalytic, if you could respond me i will apreciate it, thank you.

[@lafayettekemp8737]

A

[@gillisjunior935]

My vehicle stalls after I’ve driven for a while and try to slow down . checked my crankshaft sensor and it shows good . It’s a 2011 Hyundai 1.8L Elantra . The car runs good after it’s parked for a while even at low speeds , only does this after I drive for prolonged periods . Scanning tools couldn’t get any codes . Could you help me ?

[@Run_N_Gun83]

Man, I’ve been watching you guys for years and have learned so much about my Elantra, I’m far from a mechanic but you guys never fail me when it comes to working on my Elantra, much appreciated guy’s, you have saved me $thousands on labor

[@ssjoyce]

Used this video to replace my o2 sensor. Thanks so much. It helped me with seeing that the job was not as daunting as I would've originally thought. Thanks again!

[@haileymacisaac5089]

Thanks for all the amazing videos! They wanted to charge me $500+ to replace mine, I’ve been quoted at two shops. This is the best video I’ve found on doing it yourself!

[@ifuaintfirsturlast7551]

I've used 3 of ur videos to repair a veloster...awesome content!

[@theherbpuffer]

Thanks for the video! I was having a hard time with unplugging it but now I know to pull up on that tab. Videos like these are priceless!!

[@robn729]

Hey guys i really appriciate these elantra videos, i own an elantra myself. I've seen like all your elantra videos, thank you!

[@dhflannagan1]

Thank You. Good job with the camera placement in an area that I know is a very tight spot.

[@mikeh4924]

Thank you so much!!! Working on my 2012 Accent which is not the same but you guys point in the right direction with your videos.

[@kwebb4078bn]

Lol me too. So far I have made it to 149k on my accent. I hope to get it to atleast 200k before I overhaul the engine and transmission or junk it.

[@Smile-uwokeup-2day]

Thanks car guy for all ya vids on my Elantra that I used to repair rear brakes alternator n valve cover gasket . N throttle body

[@SuperTurboAE111]

Do you have one for the lower O2 sensor? Do you know where is the socket located? thx

[@omaromar13]

Please make video about the other oxygen sensor near the catiylic converter

[@grilldoggy793]

great advice and excellent accent

[@DaughteroftheKing67]

I’m not a mechanic but watching this video it could say me well over $200 in charges to do this myself instead of going to a shop!

[@Smile-uwokeup-2day]

I agree I used this car guy to repair my alternator n brakes rear n valve cover gasket also . I have to replace this part here n VVT WHEN I CAN .

[@jorgetoloza269]

Thank you very much well explained.from Florida

[@user-rd4gz1nc4e]

Great video. Thanks

[@MrPeterHaller]

You guys are the best I love your videos I love how you break it down to make it simple for the novice mechanic. I have a 2007 Hyundai Entourage I'm getting gas fumes out of my tailpipe and knocking and low power when I try to go uphill or to accelerate I'm thinking the oxygen sensor upstream needs to be replaced I'm being told there are two oxygen sensors do you know if there is two or is three total two in front of the catalytic and one after the catalytic please let me know thank you

[@landenf9]

theres one before and one after. down stream as after the cat under the car

[@landenf9]

probably need spark plugs too

[@dangerousmoogle2876]

The o2 sensor for the 2013 Hyundai elantra coupe gs isnt in the same place Where will that be located at? Also can you do a video on how to change the transmission fluid?

[@BeardedandBlessed]

Can you make a video for replacing downstream sensor?

[@ActualLiteralKyle]

Bump this

[@noelle7591]

Thank you guys that was so helpful👏🏻👏🏻👏🏻👏🏻

[@ivisheshpatel]

Hi , can you make a vid on where is the location of block heater in elantra 2012 1.8 ? And how to install ?

[@jrock-xs9vp]

Great video helped me alot

[@PocketChangeInspector]

Does the 2017 Hyundai Elantra 2.0L have two upstream O2 sensors? I see the one in the heat shield and then what looks like another just below it in the exhaust pipe yet before the catalytic converter. Thanks!

[@jaypower2797]

By any chance, do you guys have a video regarding the tools needed, and the steps to change out the upstream o2 sensor on a Sonata (2013)?

[@kathymurphy7056]

Can you make a video that shows how to change all 4 O2 sensors on 2008 Hyundai Azera limited

[@robertpaulson341]

Great video!!! Will the check engine light go out automatically after changing the sensor or does it have to be manually reset?

[@HircineDaWolf]

you must always reset, but it may reset itself after enough drive cycles

[@HircineDaWolf]

@@anon368 clear codes

[@lloydsmith1306]

I have a 2011 Hyundai Elantra and I'm looking to replace the Upstream O2 sensor. The problem is it seems that my Upstream is actually located a little bit further down the exhaust pipe and not directly behind the engine as I'm seeing. I would love to share a picture but unfortunately there's no way for me to show you. Would you happen to have any insight on this?

[@Rob-ji8gm]

Experiencing the same issue with a 2013 Elantra. Gotta get a cheater pipe over your ratchet or come at it from under the car. Get a little push into the hoses to get a little more leverage. It seems hyundai doesn't know what torque to put things at u.u

[@nils4137]

Ooof I have the same problem. Not the same location on my 2013 Elantra.

[@harishankars9855]

Very helpful. Thanks.

[@aprilmarie8750]

Is an accent the same? I'm trying to learn all the parts under my hood. I just had the ecm replaced. I changed the purge valve myself. It is now stalling while idling. I think I need to change the crankshaft sensor. But I'd like to know where all the sensors are.

[@jimnewberry]

Thanks, this is helpful. One question though, at 5:30: very important to not cross what?

[@dustinblake3115]

very important to not cross thread and strip it. Then you'd have to tap it, or the socket would just pop out

[@henryreyes7788]

Can you show how to do some car repairs on 2016 hyundai santa fe sport, thank you.

[@Vpzoe]

GREAT videos!!! Thanks guys! Liked N subscribed!

[@danbillion45]

Please I want to know which one is the 02 sensor 1

[@PaweSzpak]

What is the socket size? Is it the same for both sensor? In my i40 fuel consumption drastically increased recently and engine has less power from time to time, what sensor do i replace with that symptoms? Is it the bank 1 sensor 1 or 2?

[@jeffGordon852]

How many updatream o2 sensors does a Tucon 2012 DOHC has please?

[@ERDESH01]

What about the rear most o2 censor?

[@ZekeITS]

Perfect, thanks!!

[@hogica]

What is the torque for the upstream oxygen sensor?

[@endyramirez5242]

I have a 2013 Elantra limited and I can only find the downstream sensor. I’m checking the location on top of the manifold and it’s not there??? Does it only have one sensor ??

[@turokch2]

Hey does anyone know what the brown paste that comes with the sensor is ?

[@michaelpenchenski9651]

What is that special socket called

[@jacobrogers6684]

is bank one the first sensor

[@melissaname2740]

Is it a 4 wire or 5 wire oxygen sensor? I have a 2015 Hyundai Elantra sport 2 liter 4 cylinder engine

[@maherali6053]

Hi friend. I have elantra 2013. The car runs perfectly at the biggening of each trip but after maybe one hour of driving the engine starts to do some unusual noise like clicking sound (tic, tic, tic....) and seems like it it's losing power. And when i slow down or climbing a slope it finished by vibrating and stalls. Hearing this sound, i try to give it much fuel to speed up the sound diseapper but reapper a few moments later and finishes by stalling at the first stop signal or slowing down. Sometimes it stalls at the traffic at low speed. I need each time to restart the car it's really embarrassing and could be dangerous sometimes. The computer diagnosis made three times one of which in hyundai but tells me that everything is perfect and absolutely no anomaly detected. I changed the battery, the throttle body and the crankshaft sensor. But the problem is always the same as i never did anything. I Need your help i really get tired.

[@ellebear6598]

Did you find out what’s wrong? Mine does the same it’s finally died now!! They keep saying 02 sensor but it’s not

[@darrellmaria6356]

Can you clean it with carb cleaner and install it again??

[@markjaysonsomera536]

Thank u sir

[@yassineyassine5097]

Brother any help please im confused i have a 4 clynder 2013 Hyundai sonata gls i have a check engine code bank 1 sensor 2 im confused witch 1 is it any help please

[@fliptactics2524]

Would this work on 2010?

[@angelpelaez17]

When its a bank 1 which sensor is it?

[@sujinrajesh4986]

Is this bank1 sensor 1?

[@stuff_n_thanngs7552]

Did u ever find an answer? I just got the bank 1 sensor 1 code today. P2626

[@mediaanarchy-captaino8961]

does the defective upstream sensor cause the vehical to buck like an earthquake and jerk realy hard if you put the pedal to the floor on hard take off or try to pass at freeway speeds ? it runs good if you drive with a feather foot but try to take off quick or pass on freeway and it jerks multiple times realy hard then goes into limp mode....no codes and amonia smell from exhaust !!!!!!!!

[@brandonreed7356]

Late response but I would say to change it out it also could be a crack in the exhaust pipe or manifold

[@Gamingpadhdhsg]

Is that bank 1 sensor2?

[@kitmedjesky1024]

i have a 2013 hyundai elantra GLS. The upstream sensor does not appear to be there. What am I missing?

[@zq7028]

My car Hyundai Elantra 2013 is giving a very bad fuel average, approx 8.5 km/L, i changed all spark plugs, coils, injectors cleaned, cataylic converter cleaned but still the fuel average is very bad, any further idea please?

[@sujinrajesh4986]

Bank1 sensor 1 is the same one this video

[@paulquinonespq]

how you know if your transmission done?? my car goes in reverse fine and doesn't go forward.

[@dv534]

Dealer is charging me 1.5 hours to fix this so how long does it really take to replace ?

[@andrew4982]

The hardest thing to undone is the connector. Every single connector in the car has a different locking mechanism. Why they cannot just use one type its the same manufacturer?

[@joseperiv]

Original oxygen sensor is bosh??? In hyundai???

[@glockks56]

Is that the same as the mass airflow sensor?

[@frankgriffin6977]

No

[@vincentiiramirez8185]

when should i replace my oxygen sensor?

[@فخريخضيرالخفاجي]

how to test 5pin up streem oxygen sensor on 2005 hyndai elntra

[@williamforney8769]

How many O2 sensors is Ono on Alandra Hyundai 2012

[@agt0822]

William Forney 2 upstream and downstream

[@josephmelville1]

What was your symptoms

[@yehudahardoon3567]

I have a 2012 Elantra and the sensor isn't in the location shown in the video and I can't find it....can anyone please help?

[@jordank9890]

It should be. I have a 2011 and it’s there.

[@АлеханОрлов]

it is impossible to unscrew it. The edges are already starting to break down😭

[@geoffreyrawlings9736]

Prefer the original intro music.?

[@neilwilliams2193]

Did you know that if you soak your oxygen sensor in toilet bowl cleaner for 15 minutes you will have a new oxygen sensor?

[@Soulenergy31]

What are the consequences of a bad OXYGEN SENSOR ?

[@kevinmeadus7827]

Why can't you just cut the oxygen sensor wire off and put a 3/8 ratchet instead of buying a new device?

[@roncox8758]

Because when you put the new one on you cant cut the wire on it. So either way you'll need the socket.

[@stuff_n_thanngs7552]

What a dumb question lol

[@CarlosAlex-x2m]

We’re are you bary

[@igotstoknow2]

Real mechs know how to disconnect connectors and they don't wear pimp watches.

[@reno5948]

Why would you work on a vehicle wearing such a fancy watch and ring?

[@emmanuelarayaaraya7380]

Number parte plis My friend

[@markjaysonsomera536]

Thank u sir