Bagged C10 Build: Start to Finish

[@TalkedAboutcustoms]

What upper control arms did you use ? It corrected your camber ?

[@TiktokTiktok-n2e]

Exelent video bt sTpid bored song👍🏻👋🏻

[@NoahJordan-q3e]

Learn to type in English properly before you run you’re mouth

[@khg_7]

Hi sir where did u mount the shocks?

[@jrewing8012]

Awesome. Needs drop spindles

[@PickleFab]

It had drop spindles. It needed a frame z or an aftermarket crossmember up front to get it to lay flat out

[@jesusarzate5927]

What measurements did you use for the notch

[@Nizzwell]

Hey fella can i ask how deep the chassis notches are on your truck.. cheers

[@PickleFab]

If I remember correctly they are about 8" notches.

[@Nizzwell]

Awesome chap ...

[@davidsewell5764]

Did you pancake the front crossmember or anything?

[@PickleFab]

No. Stock from crossmember with ektensive front arm kit. It still was hung up in thr front on the crossmember. I would have rather done an aftermarket one, but the customer was on a budget

[@davidsewell5764]

@@PickleFab and sitting on the crossmember it still gets that low as I the video? Trying to decide if buying a crossmember or pancaking mine is worth the money or time. I'm not really worried about laying the body.

[@PickleFab]

@davidsewell5764 I would say it's worth it. This truck was about 1.5 " from laying frame towards the front. If that doesn't bother you than it might not be worth it. But I always prefer to see the truck fully laying frame front to back

[@RPMlegacy513]

Did you do a body drop to get the cab that low?

[@PickleFab]

Nope. That's just bagged front and back

[@efrenzermeno9511]

What size are the rear wheels and was the rear end shortened?

[@PickleFab]

If I remember they were 22x10 and the rear was not shortened

[@Nizzwell]

Did you cup your front arms at all.

[@PickleFab]

No. They just had the bag cups bolted into the lower arms

[@Dragracetherapy]

🥒🔥🥒🔥🥒🔥🥒🔥

[@TalkedAboutcustoms]

What upper control arms did you use ? It corrected your camber ?