In this video I show how to use the manual fire feature to cut large sheets down to size without a G-code program.
Пікірлер: 13
@mikebell8095 Жыл бұрын
Great video. Thank you for being real... i am a fabrication/welding instructor and i have done the same thing in my shop and classroom. Great job again. Awesome video
@theodorebowers97373 жыл бұрын
I Feel for you I was Screaming at the TV check your ground thaks for your videos I just got L/S table not long a go having hard time old and been real Sick for about 18 yrs getting bad plain all the time and old have stop for a like real bad right now but like your videos thanks had fun lol.
@BecksArmory3 жыл бұрын
Trying to work and film at the same times adds a lot of distractions. Stuff like this happens all the time when I got life. hahahaha.
@theodorebowers97373 жыл бұрын
@@BecksArmory I know just how you feel it was funny
@formekinetics6913 жыл бұрын
Extra info...if you use the DRO to move 1" and you want a 1" part....need to consider the torch cut thickness and account for it. If your torch cuts .055 need to move DRO 1.055 to have a 1" part. The movement of axis is center to center of torch cut. Half of cut added to each side....which is full cut width added.
@jonbozzy96003 жыл бұрын
I have 1/2 thick x 3” flat bar. Do you thick that it can cut it with straight edge? I
@alexgrassi3203 жыл бұрын
If I could have $1 for every time I forgot the ground clamp while welding or cutting... Thanks for sharing
@LagmasterB3 жыл бұрын
Dude. Awesome.
@petey_productions29007 күн бұрын
Your awesome 👏
@BecksArmory7 күн бұрын
You too
@formekinetics6913 жыл бұрын
Ground clamp???...Edited..see you figured it out after watching all video.