Well done young man! I use mine outside its intended range and its not let me down yet.
@jkoeberlein13 жыл бұрын
Absolutely loved those cuts!
@0lddragracer4263 жыл бұрын
I just got mine, but I haven't used it yet. Very nice little review you did on this machine...good job. I'm impressed also. Make it available to Yeswelder, and they might send you some of their machines for you to review.
@protovault3931 Жыл бұрын
All the info I needed! 10/10 video thank you
@TheRockhavok8 ай бұрын
Really informative. Thank you.
@readchp2 жыл бұрын
Very well done video demonstration and very clear presentation. Many thanks for your efforts.
@danielpullum19072 жыл бұрын
You did have preheat on the multi cuts you made on the tapered bar. You feed control is very good. They mentioned air pressure chgs on some cuts. So, feed rate, amps, and air psi seem to be the key for smooth slag free cuts.
@emptyb9968 Жыл бұрын
Nice review. Really dig the outdoor shop.
@brentcogswell68843 жыл бұрын
Good review. Info is good. I might have to look into getting one of these machines.
@chektay8882 жыл бұрын
Hi Jake, Thanks for the great work doing the review. I have a question if you don't mind. The spec for this machine recommends using 63 Amp breakers. I just wonder what amperage of the breakers you used to do this demonstration. Do you think this machine can work with 40 Amp breakers?
@reloadnorth7722 Жыл бұрын
20 Jan 2023. Hello. How about a long term update. Tell us how it is still performing and should we purchase one. Thankyou.
@coreyellisart68772 жыл бұрын
So my biggest question is Chinese simadre 50 amp plasma cutters for about ten years now my Miller blew out and I bought this temporarily and it's been working for so many years. I'm debating on getting the new yeswelder 65 plasma cutter have you compared this plasma cutter to the 50 amp I'm wondering if it's a true 65 amp or if it's just fake ratings
@mikemetz14672 жыл бұрын
Where did you get the air flow gauge for the torch head, that you used in this video
@FormulaJake2 жыл бұрын
It came with the plasma cutter from Yeswelder
@chrispearce92242 жыл бұрын
Nice video sir.
@Wreakmayhem Жыл бұрын
Were you running this off a generator?
@FormulaJake Жыл бұрын
No. 240V wall plug
@miguelzamora777 Жыл бұрын
Will it run on 50amp breaker?
@FormulaJake Жыл бұрын
Yes
@damienmikkelsen60562 жыл бұрын
Hahaha!!! Formula Jake for the win!!!
@RainchildAdventures2 жыл бұрын
How is that plasma cutter doing now Jake?
@FormulaJake2 жыл бұрын
I should probably replace the tip, but it has withstood some pretty bad abuse by now. Still works great!
@RainchildAdventures2 жыл бұрын
@@FormulaJake Origianl tip has lasted 7 months or more?!
@FormulaJake2 жыл бұрын
I certainly don't use it every day but it lasted many months of weekend use. Didn't turn to crap until I tried to cut through more than an inch of steel in a pocket that wouldn't clear out 😂