Blade Nano CP S / Nano S2 Servo Replacement

How to replace the right-side and rear servos in the Nano CP S helicopter. The procedure is the same on the Blade Nano S2.
Sorry about the focusing issues, and poor resolution video due to the digital zoom. I did the best I could with the equipment I had at the time.

[@terjeoseberg990]

Does DeoxIT Fader spray evaporate? The spray I used to clean out the servos on my mCP X twitchy servo was really greasy. I had to rinse the whole helicopter in 99.9% rubbing alcohol to get it off. But it solved the problem. No more servo jitters on this thing. I sprayed it into all the servos, then with throttle hold on I exercised the servos along their full range, then blew out as much as I could with an air compressor, then flew it for a while, then cleaned it all of with the rubbing alcohol.

[@samirkorchi]

👍🏽

[@terjeoseberg990]

BYW, instead of buying new parts, buy someone’s crashed/broken helicopter and use it for the parts. For less than $60 you can get a whole other helicopter. I have 4 mCP Xs and now that I’m on my last tail boom and swash plate, I’m going to finally buy some 2mm carbon fiber rod and a few new swash plates.