BMW E36 M50 Manifold fitting guide | How to fit M50 manifold | MS41 ECU Remapped

How to fit the M50 manifold to the m52b25 or m52b28 engine.
In this episode we do a how to guide on fitting a BMW e36 m50 manifold to the m52 engine.
We explain the fitting kit and map the ms41 ecu.
One thing I have not mentioned in the video is we use the intake temp sensor from the m52 manifold, you need to cut a thread on the plastic m52 intake sensor for it to thread into the m50 manifold.
If you have any questions contact me on instagram @GaragE36_uk

[@TwistedTattoo.WarShorts]

Brilliant idea for a video mate👍

[@GaragE36uk]

One of my subscribers asked if I could do one so thought I may aswell while I had one in..

[@TwistedTattoo.WarShorts]

@@GaragE36uk 👍

[@robertbaker6012]

😉

[@CYMRU619]

Would be great if you made a similar vid going through welding in new rear arches! You must have done a few by now haha

[@GaragE36uk]

We have done some yes. Sure there are some pictures on our Instagram. Next set we do I will make a video.

[@lolitagupta2201]

In EU we got the 2.0 version single vanos of the M50 carefull with that intake. It wont fit proprelly. It will fit on the 2.8 but has a small gap ( cilinder head ports to big for the M50B20 Intake) its possible to make it work but if u work into problems u know what it is. Just leaving it out there so no one deals with the same problem as i did.

[@GaragE36uk]

Thanks for the comment. Was never aware of that.

[@krislees976]

Great work guys, ive got the same setup but i dont think the map ive got on there is right. could you share your partial 24kb for the m50 manifold so i can compare?

[@robertbaker6012]

Brilliant mate 👍🏻 I think you'll get alot of views for this video, it sounds alot easier after watching your video. I just finished off my rocker cover gasket yesterday, so if I get time in the week I'm going to try & pull the manifold off mine & change the starter motor. How much are your kits? Keep up the good work mate 🍻 Legend!

[@GaragE36uk]

Thanks mate. I remembered you asked about it, so thought I would give my subscribers what they wanted ha ha.. Think the fitting kits about 35 quid and the 90° intakes are 46 mate And thank you once again.. Appreciate the support..

[@robertbaker6012]

Appreciate you taking the time to make the video mate how do I order those bit's?

[@GaragE36uk]

@@robertbaker6012 if you drop me a message on Instagram I can get them sorted mate.

[@matthewladds7656]

Only thing id add is about not using the m50 intake temp sensor

[@GaragE36uk]

I have added in the description mate. I remembered I had left it out when I uploaded the video..