BMW E46 M3 Purge Valve Issue (Code P0444)

GET YOU SOME MERCH AT www.YEVSBuilds.com
Donate to my channel: paypal.me/ynd94?country.x=US&...
Make sure to follow our Instagram for some of behind the scenes updates @YEVSBuilds
Music released by Carbon Citizens
/ carboncitizens
Click Here To Stream On All Platforms: fanlink.to/CCallstream
#bmwm3 #e46m3 #bmwproblems

[@YEVSBUILDS]

Make sure to like/comment/subscribe and follow the Instagram @YEVSbuilds🤘🏻🤘🏻

[@rodger6940]

Hey thanks for your videos right now I'm dealing with the p0444 I have until the end of May to get my emissions test But I changed the purge solenoid valve but nothing I noticed that every time I erase the check engine for the code soon I restart the car it comes back up in a matter of seconds (20 to 30 s) do you think is the pcm that is shorted to ground?

[@YEVSBUILDS]

@@rodger6940 I mean possible, but unlikely I wouldn't think. I'm not sure bro

[@AliWNwry]

Well done sir

[@marknoir]

Hi. Thx for the video. I have quite a few of your vids saved into my “E46 M3 repair” playlist. Question: you mention that there’s another purge valve near the gas tank under the large cover. I tried to find it on RealOEM, but only found a leak detection pump there. ? Thx.

[@filipebmwm3]

Great video! Thanks for the diy. I’m having the same code. Going to change on mine also.

[@YEVSBUILDS]

No problem bro. Good luck

[@malkufahy4978]

Shall i reset the check engine light after replacing? Or wait till it goes away by itself?

[@phallock73]

This Is Great.. I have a Lot of Issues.. I might need your help if Possible.

[@b577960]

Is there a trick to get the bottom hose off. I cannot get it off- do you push the plastic ring bit in or do you pull it out, do you squeeze it, do you twist it off. I would greatly appreciate your advice on this?

[@YEVSBUILDS]

Dude I was struggling to get that hose off as well. Its just one of those things - you gotta keep trying and twisting it and whatnot until it comes off, no trick really.

[@dog2bert]

Is this part was causes the idle rpm to surge at startup? I just thought all E46 M3 had a slight surge at startup

[@YEVSBUILDS]

I've heard of E46's having the idle be a little rough at startup but in my case, replacing this piece helped a ton with the idle. So from my experience, I can say with confidence that the Surge Valve definitely helps at least a little with the rough idle. -Eugene

[@brianveltri3107]

Valve didn’t fix mine

[@BASKxx]

Do you happen to know the Part number to the part u used? Everything I’ve found so far says does not for the M3

[@YEVSBUILDS]

13907831770

[@ruthwright6247]

Thx u

[@YEVSBUILDS]

Any time!

[@phallock73]

Would this help with the Fuel Tank Acting like it's FULL when it's barely at 5/8 full? I always put Premium 92 or 93 octane in. I just replaced my Crankshaft position Sensor and it ran good for about a day.. the Crankcase Vent Hose that's located next to the Sensor you replaced under the Air intake manifold has 2 Broken prongs and won't stay in place..

[@YEVSBUILDS]

No that would be your fuel sending unit going out I'd assume.

[@phallock73]

@@YEVSBUILDS Just to clarify...That's not the Same as the Fuel Leak Detector .. Just watched almost all your M3 E46 videos.

[@luckycapone8571]

I need help with my e46 m3, it was involved in a crash and now it won’t turn on it has crank but no start idk if it’s the fuel pump, tank venting valve Tempomat I’m lost no lie

[@YEVSBUILDS]

Bro it could be so many things! But it's odd that it started doing that after a car accident...

[@alexbrown916]

Any idea why this would go bad after head rebuild? My head was rebuilt and this came on a few weeks after just like you said. Great video!

[@YEVSBUILDS]

Seriously? That's so odd.. Yeah man, I have no idea why, but if it's a thing, then I'd love to know why!

[@CallM3CJ]

Where did you purchase the part from.

[@YEVSBUILDS]

Just a local German car parts store in Portland. Best case scenario, a dealer would always have these.