BMW M1000RR IAT Issues stock and how to fix it

[@colts0713]

Great video! Can't wait to get my kit and flasher in mail!!

[@badass1g]

My 2020 R1 shows a temp that is way off from what it actually is. Is this also hurting power on my bike?

[@heero3578]

yes, because it's reading the temp from the airbox instead of what the temp is outside!

[@swatboss1]

@@heero3578 can changing the IAT sensor location to a cooler place cause the bike to overheat? I mean does it effect when the fans start blowing air throuhg?

[@robdridan4240]

Flaps can be programmed to be open all the time. IAT deosnt adjust mixture in isolation, O2 sensors play a major part and will read lean if not enough fuel. So I'm sceptical of the need for IAT relocation

[@heero3578]

All the iat does is read temperature. relocating it to the nose of the bike will keep the power constant instead of it being cut by the ecu 1nce it reads the temp from the hot ass air box it's plugged into. U don't need to flash the bike for that but that's the way they sell it!

[@strawberry4565]

Can it beat Ducati V4SP?

[@BT_Moto]

One way to find out

[@heero3578]

very detailed & informative, Nice!!

[@grider8344]

How much power does it actually loose, percentage?

[@BT_Moto]

Depends on a lot of factors

[@mike-thebike5757]

if its more than 90 deerdees Celsius wather themperature you loose 4-5 Hp at the wheel ....

[@grider8344]

@@mike-thebike5757 thanks mate, I m shocked that much.

[@mike-thebike5757]

@@grider8344 jehhh the new BMWs are very sensitiv at high themperatures ...

[@ravenmoto5948]

So open the flappers through software to always open.

[@BT_Moto]

We can do that, yes

[@travislp91]

I just ordered the stage 2 kit for my 2021 s1000rr with handheld. Will that software come with the tune for flappers open all the time? Or does it need added? I didn’t see any options. Thanks

[@swatboss1]

did you get an answer to your question somehow? with stage 1 is it always open?

[@baderalorayir5236]

I already have stage 2 on my bike but I haven’t installed the IAT kit , my concern now is the flapper opens below 6k RPM

[@BT_Moto]

With the flapper open only, it won’t improve performance or affect the bike negatively from stock. Just leaving performance and rideability on the table is all.

[@swatboss1]

@@BT_Moto can changing the IAT sensor location to a cooler place cause the bike to overheat? I mean does it effect when the fans start blowing air throuhg?

[@BT_Moto]

@@swatboss1 won’t cause any overheating. Engine fans are controlled by coolant temp, not IAT.

[@swatboss1]

@@BT_Moto it is very nice to see everything I will do via brentuning is crystal clear.

[@swatboss1]

@@BT_Moto should I buy stage 2 for the intake flappers to be fully open all the time? I dont want to remove them.