AeroFlow Dynamics V1 & V2 Front Lips - VB WRX Install

[@andreaelswick6434]

When putting on the first lip were there holes to drill into alresdy or do you just use your best judgment on placement of the screws

[@BoombaRacing]

Hi! It was mostly a best judgement thing, the plastic directly under the bumper generally has few wires, if any, unless you have additional aftermarket wiring going through the area. We used pretty short self-tapping screws so there was not much concern on penetrating further into something we didn't want to. Hope this helps!

[@spacedmellow5031]

When installing the v2 did you drill in the already existing holes from the v1? I’m curious cuz I want to switch the the v2

[@BoombaRacing]

Hi! That is correct, as long as the holes have not been drilled too many times over we should not see any issues regarding the lip securing the bumper. Definitely loving the look of the V2!