Rookie here. Good stuff to know. I'll be following this procedure my Outlander Max arrives in a few weeks.
@j.c4life3 жыл бұрын
How do you cover 50/km in only 20 minutes not exceeding 4k rpm? 🤔
@ziadajam54332 ай бұрын
How many cycles for that belt to flex and break in?
@rodneyjones60694 жыл бұрын
So I did this when I installed my new belt an there is smoke coming from my belt drive snorkel pipe , any idea why it is smoking ?
@dawgluver924 жыл бұрын
Because this is no where near the correct way to break a belt in.. I have always used the rule to not go into high gear until 30 miles of low gear not exceeding 35 mph all the while. I also go through about 4 heat cycles at around 7 miles per cycle letting the belt cool in between. Also be sure your clutch sheathed are nice and clean and don't have excessive residue so that the new belt wont slip. And lastly make sure to wash the new belt in warm soapy water to get the "release agent" off of the belt. I myself use the old dishwasher trick to aid in that process then let it dry a while.
@ademkovacevic73554 жыл бұрын
James Carter Hi, i have big problem with my can am outlander 1000r xmr , i changed two belts in last 2 months wich means one month one belt i dont do wheelie or something like that but it breaks so often pls help should i buy maverick belt and put it on my outlander and what i should do before i installed it pls help
@alanramos74642 жыл бұрын
@@dawgluver92 30 miles of low gear?? That would take hours😂
@JuanRodriguez-hy5pj Жыл бұрын
@@dawgluver92 I have 3500 miles on my x3 and i just went 15 miles in low gear and let it cool down ,just keep your clutch box clean
@killer2591 Жыл бұрын
I keep getting conflicting opinions on breaking in. Mostly about how NEVER go slow in high. Went through 2 belts now and have had so many dif reasons for why. Going under 30 in high was 1 reson. Driving threw a puddle of water (even tho It has snorkels on it). One guy said u have to warm the belt up eventime driving at least 15 miles. Like for real? Shit was 40k no way something new has this many problems
@garydevoll84042 жыл бұрын
Where does one buy that helmet
@atvlifefam24243 жыл бұрын
Crazy I full sent my shirt
@ademkovacevic73554 жыл бұрын
Hi, i have big problem with my can am outlander 1000r xmr , i changed two belts in last 2 months wich means one month one belt i dont do wheelie or something like that but it breaks so often pls help should i buy maverick belt and put it on my outlander and what i should do before i installed it pls help. @CAN-AM OFF-ROAD
@kevinmisamore85352 жыл бұрын
I have this same issue with my xmr, did you figure this out??
@Dsrterra Жыл бұрын
Check the belt rotation
@PlayafromtheHimalayas2 жыл бұрын
So drive it like a Honda at first. Got it
@payasotunkatumadre8762 жыл бұрын
Lo
@X3Andy4 жыл бұрын
So....basically don't drive it like a dick? Got it.