How to install a gas tube into a gas block

[@blbowers]

Imagine having no idea how to swap a gas block, assuming it's easy AF, trying to figure out how to get a too-big roll pin through the too-small roll pin hole, sweating, cussing, crying.....then finding this FREAKING KING on the KZbins! Bro this video is a panty dropper! Thank you!

[@hugomora8100]

Watched so many videos and this one explained it the best. We’ll done sir.

[@russellwilson1906]

Awesome that worked wayyy better, I also used some hoppes 9 gun oil, a drop on the pin and a drop in the pin hole, slid right in no problem

[@josephcuison5412]

I use a toothpick as slave pin to make sure the hole doesn’t get misaligned as I start punching

[@phenomkrumper]

Nice, I'm definitely gonna practice this many times as the first couple tries I mushroomed the roll pin. Probably the most frustrating pin to install when building if you ask me. I plan on fashioning a jig/setblock for future installs though.

[@Breakbeatz2591980]

Flat face channel locks with masking tape over the face. Equal pressure from the side of the block to the roll pin, prevents using a jig

[@danieltownsend73]

What kind of roll pin starter is that. I ordered some and the suck.

[@BTOMF]

Just a set I ordered off Amazon. They're great if you use the right size.

[@danieltownsend73]

@BTOMF I ordered a roll pin set off Amazon as well and they are not so good

[@kris66503]

THERE'S A ROLL PIN STARTER PUNCH?!?! THAT SOB WOULDVE HELPED ME SO MUCH 30 MINUTES AGO!!! AAAAAAAAAAAHHHHHHH!!!

[@mikehancho1613]

I use just a smudge of grease goes right in. You can also have someone hold a punch through the bottom of the gas block/tube to help guide the roll pin through properly

[@lzxray6781]

How tight do you need to clamp the block into the vise? I don't want to mess up the ends!!

[@BTOMF]

Tight enough so it'll hold it and not move. You don't want to gorilla it in there.

[@lzxray6781]

@@BTOMF Thanks!

[@mixdbyjoshua5621]

Where’d you got the roll pin starter set?

[@andrewvan-aarde5697]

Wheeler makes one for $18, or Amazon has one for $7.95

[@EdSigman]

Thank you!

[@C_oprator89]

You forgot after you blow to feel for air and proper alignment that if you feel a tap on the top of your head to keep blowing 😊

[@railroader8728]

What size starter was that 5/64? Thanks

[@nickol9692]

Thank you!!!

[@--RSL--]

Hate those damn pins dude. Someone needs a better idea.

[@xxx-ln9gv]

Hahaha