BTT Octopus - CR10/Creality Display

[@ximesxiang4933]

Nice... but how to fix that washout?

[@EdwardBraiman]

Camera is the issue.

[@Skudiero]

hello good morning, could you give me a hand with the calibration of the plate? when I do the z off, it doesn't position itself well, the first check it does in the center then it moves too much to the side, but when I do the bed leveling calibration, it checks the entire plate correctly. I don't know if you understood the type of problem Thank you

[@EdwardBraiman]

There's a link to Discord in the description where either myself or someone else can help.

[@Skudiero]

@@EdwardBraiman hi I wrote to you on discord I put the link to the video

[@rustyv6274]

Can I install this board on an elegoo 4max and use klipper?

[@EdwardBraiman]

Probably Yes.

[@philipmann-f8f]

I would like to join the Patreon site, but I would like to ask you a simple question. I did the 'buy me a cup of coffee' and bought three cups and asked a simple question, but no reply. Do you ever read the comments? ?

[@EdwardBraiman]

Just answered.

[@kiahalhay1163]

hi, your videos are a great help for me. Plz make a video for Marlin based active heated chamber temperature control. i have dual extruders enabled and want to use MKS Robin Nano V 3.1 to actively control my chamber too.

[@EdwardBraiman]

Currently I need a chamber to do an example configuration . The concept is similar to a heat bed tutorial in playlist.

[@fefefefe732]

Dear ED..I would like to ask you a favor..if you know how to use any motherboard on the market (BTT, MKS ext ext) if you could make a video sometime on how to configure the Marlin so that the printing interruption continues..what needs to be set and where to make the resume printing appear on the display..because I don't have that in the menu and I can't interrupt the printing because it doesn't show the option to continue...thank you..maybe it's not only me who would benefit from such an instructional video..sorry for the for bad English, but what you see here I wrote for you with the help of google translate.. I can't find the part in Marlin anywhere, the setting that allows writing to the sd card the option to continue after a possible break... thank you, I hope I didn't bother you...

[@EdwardBraiman]

I'll need some time. Work is busy for me until Tuesday afternoon.