How Buckman's Repairs a Snowboard Edge | The Workshop

[@Iedhunter410]

Rad video, mate! Loved watching the repairs done by hand... and the old-school tape dispenser 🤙

[@Buckmans]

Thanks. We have state-of-the-art equipment, but the most important thing is our experienced technicians and their attention to detail!

[@robnhood7780]

Well done

[@Buckmans]

Thanks!

[@TheMakss1]

Just had to do the same kind of repairs on my board , is it going to last ? is there any chances of breaking/open again ? thank you

[@32srt32]

now i have to figure out how to do it home!

[@lukaseaton3341]

Do you use ptex and epoxy together or separate? Thank you !!

[@Buckmans]

It depends on the repair. With this repair, we used a only ptex.

[@alexpregel4755]

what product do you use in the sealing phase? Thanks!

[@Buckmans]

We use epoxy to seal the repair!

[@alexpregel4755]

@@Buckmans do you mix it with liquid ptex or is it a type of epoxy?

[@IronBCC]

But seems the new piece is not welded to original edge, will it work normal under torsion?

[@Buckmans]

Screws are used to ensure the new edge will work under normal torsion.

[@fishingfreakok]

Liking the vid. basically repair summarized as chop out bad ptex and bent rail until you have a level base to work on. Epoxy and screw in the new rail cut to size. Then put ptex on top and then grind surface flat?

[@Buckmans]

That is the basics of the process. We let the epoxy and Ptex cure before giving the board a complete tune. After the complete tune, the board is ready to hit the slopes again.

[@benjaminsimard9508]

What product do you use for ptex

[@Buckmans]

Montana P-tex

[@ES-kn9fo]

That’s an impressive repair! I just damaged my edge on a rock. Any shops you can recommend in Utah or NYC to get it fixed? Thanks

[@Buckmans]

We are not too far from NYC. If you are ever down in PA drop the board off and we will take care of it!

[@ToddThurgood]

Salty peaks in Utah

[@DJStroble]

Can I send y’all a snowboard to repair?

[@Buckmans]

You can drop off the board at one of our store locations.

[@skeesh1285]

I need your repair skills on a new board that I got some damage just like this board . But I’m in wa state :(

[@Keith-v8q]

Im confused about the 3 screws you left very elevated. Were those removed prior to drying

[@Buckmans]

The screws get driven below the base of the board. Then are sealed with epoxy to hold the new edge in place.

[@alexpregel4755]

@@Buckmans what type of epoxy is that? Thanks!

[@shushevents5765]

Nice way to contaminate the base with hot swarf

[@Buckmans]

Thanks for watching! Our technicians make sure the base is cleaned and polished after the edge replacement is complete which removes any contaminates from the base.

[@checktec9582]

i mean... cool video... but why the super blurry and shaky cam the whole time? i cant see shit

[@RubenO-nu6oh]

so unsteady I'm getting sick