"I aint worried about it, itll run" been there said that 😂
@Wrenchingwithray3 ай бұрын
Famous last words lol
@Bobthebuilder.69 Жыл бұрын
U can't beat an old SBC. I have a 388 SBC with a set of ported Vortec heads in my 94 OBS Chevy. The bottom end was built in 1988 with a factory 400 crank that was ground to 350 journal size.
@Wrenchingwithray Жыл бұрын
Should run pretty good I think
@SoullessR6Ай бұрын
same motor and headers, had to beat the fire wall and there’s little to no room for you to tighten the header bolts with the transmission in place 💀
@WrenchingwithrayАй бұрын
Ya I'm going to cut the 3 bolt flange and extend it
@Darrin_Wyatt Жыл бұрын
Friends: Do you need any help? Me: No, I got this. Also, me: somebody get this car off me!!!!!
@Wrenchingwithray Жыл бұрын
Lol yup
@lancecash3617 Жыл бұрын
But I’m sure you buddy would have loved to be a part of it. Nice build
@Wrenchingwithray Жыл бұрын
Thank you!
@oldmanintheshopbuiltnotbou87267 ай бұрын
man trans dapt reccomends bolting motor mounts to the truck drop in engine then bolt mounts to the block
@Wrenchingwithray7 ай бұрын
That would probably be easier lol
@shadetreemechanicracing22 Жыл бұрын
I like my chevy engines cummins beige.
@Wrenchingwithray Жыл бұрын
Definitely different
@Idkwhatimdoing1.62 ай бұрын
What headers did you use if you could tell me also what year is the truck?